[j-nsp] VPLS with 2 interfaces on the same router

There was a discussion on this forum with the above subject concluding the below point. *The value of site-identifier must be equal or less then the value of site-range. With your current configuration if you configure this VPLS service on another router the traffic won't be forwarded over the

[j-nsp] BGP VPLS support

As per BGP VPLS RFC 4761 section 3.2.2, if the PE is connected to several u-PEs, it has a distinct VEID for each u-PE. It may additionally have a VE ID for itself, if it itself acts as a VE for that VPLS. Does Juniper support connecting PE to many u-PEs?. I have this doubt as Juniper allows only

[j-nsp] unsubsribe

Dear Moderator, I tried many times to unsubscribe but always failed although with correct password (never receive email confirmation). Please help to unsubscribe me from this mailing list. Thank you.. -Original Message- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of

Re: [j-nsp] CFEB issue

The Packet Forwarding Engine throttled next-hop resolution requests from the indicated interface, because the high number of requests might constitute an attempted denial-of-service (DoS) attack. Examples of events that generate next-hop resolution requests include an attempt to forward a packet

Re: [j-nsp] CFEB issue

The Packet Forwarding Engine throttled next-hop resolution requests from the indicated interface, because the high number of requests might constitute an attempted denial-of-service (DoS) attack. Examples of events that generate next-hop resolution requests include an attempt to forward a packet

[j-nsp] BFD for MPLS LSP Stability

Have you used BFD for detecting failure on LSP? If so, do you get false positives? tks, Alaerte part of feature text in Juniper page: === You can configure Bidirectional Forwarding Detection (BFD) on MPLS IPv4 LSPs as outlined in the

Re: [j-nsp] BGP VPLS support

Monika, For VEID, my thoughts are this is a outcome derived by the RD and the 2 bytes populated accordingly, it serves the same function, i.e. determining the outgoing label for push operation. Maybe a developer will weigh in on this though, as there is no way to manually configure this that I

[j-nsp] Flow control on optic GigabitEthernet between Juniper router and Cisco swich

Hi group, what is the best practice to configure flow control(Enable or Disable) between Juniper router and Cisco swich. Must I configure it on both devices? TIA! --- Yev. ___ juniper-nsp mailing list juniper-nsp@puck.nether.net