Hello all,
the following comes from the TeliaSonera looking glass (http://lg.telia.net/
):
Router: Hong Kong
Command: show route protocol bgp 1.38.0.0/17 table inet.0
inet.0: 518574 destinations, 1103564 routes (518516 active, 113 holddown,
1207 hidden)
+ = Active Route, - = Last Active, * =
Hi,
for what I know, MTU is part of the OSPF negotiation, so if they are not
the same on both sides, adjacency will not come up.
Vincent
On 26 July 2013 15:21, R S dim0...@hotmail.com wrote:
In a
broadcast interface (GE) I’ve to run OSPF between my MX and some systems
running OSPF.
Hi,
that one I think I can answer - we just had to do this recently, and used
CCC (
http://www.juniper.net/techpubs/en_US/junos10.0/information-products/topic-collections/config-guide-mpls-applications/mpls-configuring-layer-2-switching-cross-connects-using-ccc.html
).
With the following, frames
/var/log/messages?
That should make it world readable, so should not matter what your user
level/permissions are.
I would also compare the user/group ownership against a working box to
make sure its all the same.
On 13 June 2013 16:06, Vincent De Keyzer vinc...@dekeyzer.net wrote:
Hello
Hello,
I hope this is a simple one.
I have trouble with monitor start messages:
dude@LON2-R96-01-re0 monitor start messages
{master}
dude@LON2-R96-01-re0
*** error - couldn't open 'messages' (Permission denied) - removed ***
{master}
dude@LON2-R96-01-re0
It is unclear to me whether this is
Hi,
I'm quite new to Netscreens, so I hope this is a very easy question.
Say A.B.C.0/24 is some public IP range.
I'm trying to set up the following (SSG-550):
* A.B.C.0/27 on the Untrust sub-interface
* 10.0.0.0/24 on a DMZ sub-interface (where servers do support NAT)
* A.B.C.32/27
Hi,
(posting again since my first message didn't seem to get through)
two questions about bringing down interfaces on a SSG-550:
1. Is there a WebUI equivalent of the CLI command set interface
ethernet0/1 phy link-down ?
2. Is it possible to shut down a 802.1q sub-interface (while
For the record, response from Juniper TAC:
1. No WebUI equivalent
2. Not possible
Lesson learned: when you receive no reply from juniper-nsp, it means
it's not possible ;-)
Vincent
Vincent De Keyzer wrote:
Hi,
(posting again since my first message didn't seem to get through)
two
Hello,
I am very new to Netscreen products.
I have configured a secondary IP address on the trusted interface of a
SSG-550; I can see the new subnet in the routing table (as Connected),
but it is not advertised to the OSPF neighbor.
Am I trying something impossible? If not, how do I have to
9 matches
Mail list logo