Hi! I have an ATM-link between a M20 (JunOS 8.1R1.5) and an ERX1440 (JunOSe 7.2.0)
When I run a "monitor interface traffic" command in my M20 it looks like I am running 125Mbit/s on the link. But when looking in the ERX it only reports about 34Mbit/s. See printouts below. (I have been looking for more than 5 minutes and the M20 is reporting fairly the same). Which routing-statistics should I believe in or am I missunderstanding the printouts somehow? Best Regards /// Fredrik ---------------------------------------------------------------------- M20 PRINTOUTS: ----------------------------------------------------------------------- [EMAIL PROTECTED]> monitor interface traffic Interface Link Input bytes (bps) Output bytes (bps) at-2/3/0 Up 1048822534710 (2562560) 15370587627579 (125607352) Bytes=b, Clear=c, Delta=d, Packets=p, Quit=q or ESC, Rate=r, Up=^U, Down=^D [EMAIL PROTECTED]> show interfaces at-2/3/0 Physical interface: at-2/3/0, Enabled, Physical link is Up Interface index: 149, SNMP ifIndex: 85 Link-level type: ATM-PVC, MTU: 3000, Clocking: Internal, SONET mode, Speed: OC3, Loopback: None, Payload scrambler: Enabled Device flags : Present Running Link flags : None CoS queues : 4 supported, 4 maximum usable queues Current address: 00:90:69:54:79:59 Last flapped : 2006-12-18 11:41:26 CET (5w1d 10:02 ago) Input rate : 2564464 bps (4010 pps) Output rate : 125790720 bps (15474 pps) SONET alarms : None SONET defects : None Logical interface at-2/3/0.42 (Index 93) (SNMP ifIndex 93) Description: *** ERX linknet *** Flags: Point-To-Point SNMP-Traps Encapsulation: ATM-SNAP Input packets : 13008901668 Output packets: 23656614300 Protocol inet, MTU: 2988 Flags: None Addresses, Flags: Is-Preferred Is-Primary Destination: 192.168.1.4/30, Local: 192.168.1.5, Broadcast: 192.168.1.7 VCI 1.42 Flags: Active Total down time: 0 sec, Last down: Never Input packets : 13008901668 Output packets: 23656614300 [EMAIL PROTECTED]> ---------------------------------------------------------------------- ERX PRINTOUTS: ----------------------------------------------------------------------- ERX#sh inter atm 1/1 ATM Interface 1/1 is up, line protocol is disabled AAL5 operational status: up time since last status change: 36 days, 9 hours time since last status change: 36 days, 9 hours ATM operational status: up time since last status change: 36 days, 9 hours SONET path operational status: up time since last status change: 36 days, 9 hours SONET operational status: up time since last status change: 36 days, 9 hours UNI version: Auto-config, Maximum VCs: 16380 E164 Address: ATM E164 Address Configured: NO ATM E164 Auto Conversion: disabled ATM E164 Gateway: disabled ATM E164 Translation: disabled Current VCs: 1 Max VCI per VPI: 65535 CAC admin state: disabled SNMP trap link-status: disabled OAM cell receive status: enabled atm oam loopback-location 0XFFFFFFFF PHY Type: oc3, Framing: sonet, TX clocking: line Loopback: none, Receive FIFO Overruns: 0 5 minute input rate 34384896 bits/sec, 6932 packets/sec 5 minute output rate 2822144 bits/sec, 4010 packets/sec InPackets: 24540941887 InBytes: 10770410335746 InCells: 1103160884 OutPackets: 17761931724 OutBytes: 1577171435194 OutCells: 35857127652 InErrors: 0 OutErrors: 0 InPacketDiscards: 257005 InByteDiscards: 0 InCellErrors: 0 Administrative qos-shaping-mode: none Operational qos-shaping-mode: frame Administrative qos-mode-port: none Operational qos-mode-port: none queue 0: traffic class control, bound to ATM1/1 Queue length 0 bytes Forwarded packets 907170, bytes 74776560 Dropped committed packets 0, bytes 0 Dropped conformed packets 0, bytes 0 Dropped exceeded packets 0, bytes 0 ERX# _________________________________________________________________ Don't just search. Find. Check out the new MSN Search! http://search.msn.com/ _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp