Netters
I have tried to roll the flange for my spinner bulkhead on my lathe and it is
not working. The first attempt was 2024T3 .050. I clamped it between 2 pieces
of 3/4" particle board and bolted it on a face plate. Using a large ball
bearing mounted on my toolpost I managed to roll it about
net
Subject: KR> Spinner bulkheads
Netters
I have tried to roll the flange for my spinner bulkhead on my lathe and it
is not working. The first attempt was 2024T3 .050. I clamped it between 2
pieces of 3/4" particle board and bolted it on a face plate. Using a large
ball bearing mounted on m
e ball bat
Don
- Original Message -
From: "Brian Kraut"
To: "KRnet"
Sent: Thursday, February 22, 2007 8:34 PM
Subject: RE: KR> Spinner bulkheads
>I have always wanted to try metal spinning
Update on my Avid/VW spinner install.I just had crow for supper.Kinda
chewy but I don't mind sharing some with the net.Seems my opinion,screws
optional on the front bulkhead was,well,wrong!After 5 hours of test
flying,I noticed my vibration slowly returning.So slowly as to not even
notice.Someone s
Tommy,
I was told by one of the RV builders and pilots that you don't need screws
on the front either. However, I had them on my first KR and never had a
problem, so they will be on this one. Thanks for the post or I might have
been tempted to take the other route. Only, I use 8-32 round head.
Se
5 matches
Mail list logo
