PJM
Thanks for the powerful link, I am new at this application for
LabVIEW and don't know enough to just understand what I need to do,
but how do I get this VI to do analysis on a picture? Right now the
Block diagrams just show selection boxes where you can create logical
shift
What I would like to do is take a picture any picture really and vary
a part of it programatically so that I can do something like vary the
light intensity on a specific part of the picture.
Any ideas?
Thanks,
Brian
I am wondering how to talk to my linescan camera that is going to be
hooked up via the serial port. Right now the camera (Kodak KLI 2113)
is hooked up to the IMAQ board inside of my computer (PCI-1424), but I
need to bypass that all together and talk to the camera through my
serial port. Any idea
Ok, then what should I do? Should I re-post?
Joe,
I recently switched over the board to a Dell Lattitude. The
processor is a P3, 1gighz, and I am using LabVIEW 6.1 It is kind of
wierd because it only seems to happen when I put a probe ona certain
wire. Can I send you the VI and tell you which wire and see if it
happens to yo
When I try to run my VI on my computer it sometimes restarts, how
come?
Thanks,
Brian
Micheal,
Thanks for the link, unfortunatly though the example is in 7.0.
I only have 6.1. Is there some way to get it in that version?
Thanks,
Brian
What I would like to do is to programatically set the camera drivers
for an interface using LabVIEW. I am not getting much luck on trying
to drag and drop a non-shipped camera driver into MAX under the
NI-IMAQ/Data/ So I would like to programatically set the camera
drivers from LabVIEW. How woul
I would like to talk to my hardware through the RS-422 protocal, how
would I do this in LabVIEW?
Thanks alot for ANY help.
Brian
