Well I was wrong too it looked like the legacy rope bit but we got there in the
end thank you for clearing that up curt
Bill
From: 'Curt George' via Legacy Ornamental Mills
Sent: Monday, 11 January 2021 2:09 PM
To: legacy-ornamental-mills@googlegroups.com
Subject: Re: Same old bone, Dif
Nicely done
On Sunday, January 10, 2021, 'Curt George' via Legacy Ornamental Mills <
legacy-ornamental-mills@googlegroups.com> wrote:
> Hello Bill
> I did make a mistake, on the size, the router bit I used, its 1/8" radius
> groove bit. https://www.freudtools.com/products/20-301
> Its smaller the
Hello BillI did make a mistake, on the size, the router bit I used, its 1/8"
radius groove bit. https://www.freudtools.com/products/20-301 Its smaller then
the 1/2" pen roping bit that I have. I figured, this bit would be a good
choice due to the small size of this turning.
C.A.G.On Sun
I agree curt I have milled antler before and that was fun so I guess bone is
similar its going on my to do list for sure
Bill
From: 'Curt George' via Legacy Ornamental Mills
Sent: Monday, 11 January 2021 1:38 PM
To: legacy-ornamental-mills@googlegroups.com
Subject: Re: Same old bone, Di
Beautiful curt but don’t you mean a 1/2inch rope bit?
Bill
From: 'Curt George' via Legacy Ornamental Mills
Sent: Monday, 11 January 2021 12:32 PM
To: Legacy ornamental mills
Subject: Same old bone, Different cut
Hello Everyone
After a lot soul searching I decide to go for it. I sa
;-) So true...
But on the good side I now have lots of 7mm brass tubing so this problem should
not happen again. ;-)
Bone works so easy on the Legacy. You guys/people should really try working
with this stuff. It looks and feels like Ivory, It really is neat material to
play with.
C.A.G.
Hello Harvey.
Thank you.
C.A.G.
On Sunday, January 10, 2021, 08:57:47 PM EST, Harvey Matyas
wrote:
Curt
You did a great job!
Harvey
On Sun, Jan 10, 2021 at 7:32 PM 'Curt George' via Legacy Ornamental Mills
wrote:
Hello Everyone
After a lot soul searching I decide to go for it. I sa
Man! That stuck bolt is getting all the attention! Looking good for
sure.Keep up the good work!
Mike OK
On 1/10/2021 7:32 PM, 'Curt George' via Legacy Ornamental Mills wrote:
Hello Everyone
After a lot soul searching I decide to go for it. I said to my self,
What's the worst that could hap
Curt
You did a great job!
Harvey
On Sun, Jan 10, 2021 at 7:32 PM 'Curt George' via Legacy Ornamental Mills <
legacy-ornamental-mills@googlegroups.com> wrote:
> Hello Everyone
>
> After a lot soul searching I decide to go for it. I said to my self,
> What's the worst that could happen? (don't
Looks like a success Tim. I look forward to seeing your video.
I'm thinking you could use a similar set up for flattening slabs and also
doing dovetails with the proper bits.
A couple of questions:
1. Do you have a picture of the "extension for collets that most of
use"?, and
2. How have
10 matches
Mail list logo