Alex, I recently did a project with lots of Flash graphics and QT movies. I experienced a similar problem. What you have to do is keep the two away from each other. I found that when they touched or overlapped everything went to crap. Maybe its because they are both moving and probably at different frame rates. So to play the movies you should have your Flash pieces separate and put the QT movie in without them touching. That may mean that you have to break up your Flash interface to separate components. Good Luck. Greg [EMAIL PROTECTED] In a message dated 8/20/01 11:52:08 AM, [EMAIL PROTECTED] writes: << Firstly, Hi, this is my first posting and hope that you are fine and the weekend hangovers are'nt too bad. I have a BIG problem, I have a flash interface and have been building it for a couple of weeks now and have putting a lot of time and effort into making it. I have used director a few times before but I am by no means an expert. I wanted to include some quicktime videos in the piece to play over the flash stuff...... but its all gone pear shaped. The QT movies are flickering really badly and this is BAD. I really need a fix to stop them doing this but I have been exhausting myself to find one to no avail. If anyone can point me the right way I would be VERY apprieciative . Sorry for the desperate post, but I am scared of losing weeks of work to a technical hitch...... Thank you Regards Alex MacLeod >> [To remove yourself from this list, or to change to digest mode, go to http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list, email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED]) Lingo-L is for learning and helping with programming Lingo. Thanks!]