Ack - works in my 'unique' setup as well...:-)...
Thank you Mark!
Tom Morrison
-----Original Message-----
From: Mark Lord [mailto:[EMAIL PROTECTED]
Sent: Saturday, December 01, 2007 1:07 PM
To: IDE/ATA development list; Jeff Garzik
Cc: Tejun Heo; Alan Cox; Morrison, Tom; Hein-Pieter van Braam
Subject: [PATCH] sata_mv: Fix broken Marvell 7042 support.
sata_mv: Fix broken Marvell 7042 support.
The Marvell 7042 chip is more or less the same as the 6042 internally,
but sports a PCIe bus. Despite having identical SATA cores, the 7042
does differ from its PCI bus counterparts in placment and layout of
certain bus related registers.
This patch fixes sata_mv to distinguish between the PCI bus registers
of earlier chips, and the PCIe bus registers of the 7042.
Specifically, move the offsets and bit patterns for the
PCI/PCIe interrupt cause/mask registers into the struct mv_host_priv,
as these values differ between the 6xxx and 7xxx series chips.
This fixes the driver to not access reserved PCI addresses,
and prevents the lockups reported in linux-2.6.24 with 7042 boards.
Also add a new PCI ID for the Highpoint 2300 7042-based board
that I'm using for testing this stuff here.
Tested with Marvell 6081 + 7042 chips, on x86 & x86_64.
Signed-off-by: Mark Lord <[EMAIL PROTECTED]>
---
Patch is agains 2.6.24-rc3-git5, and should go into 2.6.24.
--- old/drivers/ata/sata_mv.c 2007-12-01 11:48:28.000000000 -0500
+++ linux/drivers/ata/sata_mv.c 2007-12-01 12:06:30.000000000 -0500
@@ -164,10 +164,14 @@
MV_PCI_ERR_ATTRIBUTE = 0x1d48,
MV_PCI_ERR_COMMAND = 0x1d50,
- PCI_IRQ_CAUSE_OFS = 0x1d58,
- PCI_IRQ_MASK_OFS = 0x1d5c,
+ PCI_IRQ_CAUSE_OFS = 0x1d58,
+ PCI_IRQ_MASK_OFS = 0x1d5c,
PCI_UNMASK_ALL_IRQS = 0x7fffff, /* bits 22-0 */
+ PCIE_IRQ_CAUSE_OFS = 0x1900,
+ PCIE_IRQ_MASK_OFS = 0x1910,
+ PCIE_UNMASK_ALL_IRQS = 0x70a, /* assorted bits */
+
HC_MAIN_IRQ_CAUSE_OFS = 0x1d60,
HC_MAIN_IRQ_MASK_OFS = 0x1d64,
PORT0_ERR = (1 << 0), /* shift by port # */
@@ -303,6 +307,7 @@
MV_HP_GEN_I = (1 << 6), /* Generation I: 50xx */
MV_HP_GEN_II = (1 << 7), /* Generation II: 60xx
*/
MV_HP_GEN_IIE = (1 << 8), /* Generation IIE:
6042/7042 */
+ MV_HP_PCIE = (1 << 9), /* PCIe bus/regs: 7042
*/
/* Port private flags (pp_flags) */
MV_PP_FLAG_EDMA_EN = (1 << 0), /* is EDMA engine
enabled? */
@@ -388,7 +393,15 @@
u32 pre;
};
-struct mv_host_priv;
+struct mv_host_priv {
+ u32 hp_flags;
+ struct mv_port_signal signal[8];
+ const struct mv_hw_ops *ops;
+ u32 irq_cause_ofs;
+ u32 irq_mask_ofs;
+ u32 unmask_all_irqs;
+};
+
struct mv_hw_ops {
void (*phy_errata)(struct mv_host_priv *hpriv, void __iomem
*mmio,
unsigned int port);
@@ -401,12 +414,6 @@
void (*reset_bus)(struct pci_dev *pdev, void __iomem *mmio);
};
-struct mv_host_priv {
- u32 hp_flags;
- struct mv_port_signal signal[8];
- const struct mv_hw_ops *ops;
-};
-
static void mv_irq_clear(struct ata_port *ap);
static int mv_scr_read(struct ata_port *ap, unsigned int sc_reg_in, u32
*val);
static int mv_scr_write(struct ata_port *ap, unsigned int sc_reg_in,
u32 val);
@@ -631,11 +638,13 @@
/* Adaptec 1430SA */
{ PCI_VDEVICE(ADAPTEC2, 0x0243), chip_7042 },
- { PCI_VDEVICE(TTI, 0x2310), chip_7042 },
-
- /* add Marvell 7042 support */
+ /* Marvell 7042 support */
{ PCI_VDEVICE(MARVELL, 0x7042), chip_7042 },
+ /* Highpoint RocketRAID PCIe series */
+ { PCI_VDEVICE(TTI, 0x2300), chip_7042 },
+ { PCI_VDEVICE(TTI, 0x2310), chip_7042 },
+
{ } /* terminate list */
};
@@ -1648,13 +1657,14 @@
static void mv_pci_error(struct ata_host *host, void __iomem *mmio)
{
+ struct mv_host_priv *hpriv = host->private_data;
struct ata_port *ap;
struct ata_queued_cmd *qc;
struct ata_eh_info *ehi;
unsigned int i, err_mask, printed = 0;
u32 err_cause;
- err_cause = readl(mmio + PCI_IRQ_CAUSE_OFS);
+ err_cause = readl(mmio + hpriv->irq_cause_ofs);
dev_printk(KERN_ERR, host->dev, "PCI ERROR; PCI IRQ
cause=0x%08x\n",
err_cause);
@@ -1662,7 +1672,7 @@
DPRINTK("All regs @ PCI error\n");
mv_dump_all_regs(mmio, -1, to_pci_dev(host->dev));
- writelfl(0, mmio + PCI_IRQ_CAUSE_OFS);
+ writelfl(0, mmio + hpriv->irq_cause_ofs);
for (i = 0; i < host->n_ports; i++) {
ap = host->ports[i];
@@ -1926,6 +1936,8 @@
#define ZERO(reg) writel(0, mmio + (reg))
static void mv_reset_pci_bus(struct pci_dev *pdev, void __iomem *mmio)
{
+ struct ata_host *host = dev_get_drvdata(&pdev->dev);
+ struct mv_host_priv *hpriv = host->private_data;
u32 tmp;
tmp = readl(mmio + MV_PCI_MODE);
@@ -1937,8 +1949,8 @@
writel(0x000100ff, mmio + MV_PCI_XBAR_TMOUT);
ZERO(HC_MAIN_IRQ_MASK_OFS);
ZERO(MV_PCI_SERR_MASK);
- ZERO(PCI_IRQ_CAUSE_OFS);
- ZERO(PCI_IRQ_MASK_OFS);
+ ZERO(hpriv->irq_cause_ofs);
+ ZERO(hpriv->irq_mask_ofs);
ZERO(MV_PCI_ERR_LOW_ADDRESS);
ZERO(MV_PCI_ERR_HIGH_ADDRESS);
ZERO(MV_PCI_ERR_ATTRIBUTE);
@@ -2490,6 +2502,7 @@
break;
case chip_7042:
+ hp_flags |= MV_HP_PCIE;
case chip_6042:
hpriv->ops = &mv6xxx_ops;
hp_flags |= MV_HP_GEN_IIE;
@@ -2516,6 +2529,15 @@
}
hpriv->hp_flags = hp_flags;
+ if (hp_flags & MV_HP_PCIE) {
+ hpriv->irq_cause_ofs = PCIE_IRQ_CAUSE_OFS;
+ hpriv->irq_mask_ofs = PCIE_IRQ_MASK_OFS;
+ hpriv->unmask_all_irqs = PCIE_UNMASK_ALL_IRQS;
+ } else {
+ hpriv->irq_cause_ofs = PCI_IRQ_CAUSE_OFS;
+ hpriv->irq_mask_ofs = PCI_IRQ_MASK_OFS;
+ hpriv->unmask_all_irqs = PCI_UNMASK_ALL_IRQS;
+ }
return 0;
}
@@ -2595,10 +2617,10 @@
}
/* Clear any currently outstanding host interrupt conditions */
- writelfl(0, mmio + PCI_IRQ_CAUSE_OFS);
+ writelfl(0, mmio + hpriv->irq_cause_ofs);
/* and unmask interrupt generation for host regs */
- writelfl(PCI_UNMASK_ALL_IRQS, mmio + PCI_IRQ_MASK_OFS);
+ writelfl(hpriv->unmask_all_irqs, mmio + hpriv->irq_mask_ofs);
if (IS_GEN_I(hpriv))
writelfl(~HC_MAIN_MASKED_IRQS_5, mmio +
HC_MAIN_IRQ_MASK_OFS);
@@ -2609,8 +2631,8 @@
"PCI int cause/mask=0x%08x/0x%08x\n",
readl(mmio + HC_MAIN_IRQ_CAUSE_OFS),
readl(mmio + HC_MAIN_IRQ_MASK_OFS),
- readl(mmio + PCI_IRQ_CAUSE_OFS),
- readl(mmio + PCI_IRQ_MASK_OFS));
+ readl(mmio + hpriv->irq_cause_ofs),
+ readl(mmio + hpriv->irq_mask_ofs));
done:
return rc;
-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html