For PHY mode, the PHYs must be brought out of reset
before the EHCI controller is started.
This patch fixes the issue where USB devices are not found
on Beagleboard/Beagle-xm if USB has been started previously
by the bootloader. (e.g. by "usb start" command in u-boot)
Tested on Beagleboard, Beagleboard-xm and Pandaboard.
Issue present on 3.10 onwards.
Reported-by: Tomi Valkeinen <tomi.valkei...@ti.com>
Tested-by: Tomi Valkeinen <tomi.valkei...@ti.com>
Signed-off-by: Roger Quadros <rog...@ti.com>
---
drivers/usb/host/ehci-omap.c | 11 +++++++++--
1 files changed, 9 insertions(+), 2 deletions(-)
diff --git a/drivers/usb/host/ehci-omap.c b/drivers/usb/host/ehci-omap.c
index 16d7150..dda408f 100644
--- a/drivers/usb/host/ehci-omap.c
+++ b/drivers/usb/host/ehci-omap.c
@@ -187,6 +187,12 @@ static int ehci_hcd_omap_probe(struct platform_device
*pdev)
}
omap->phy[i] = phy;
+
+ if (pdata->port_mode[i] == OMAP_EHCI_PORT_MODE_PHY) {
+ usb_phy_init(omap->phy[i]);
+ /* bring PHY out of suspend */
+ usb_phy_set_suspend(omap->phy[i], 0);
+ }
}
pm_runtime_enable(dev);
@@ -211,13 +217,14 @@ static int ehci_hcd_omap_probe(struct platform_device
*pdev)
}
/*
- * Bring PHYs out of reset.
+ * Bring PHYs out of reset for non PHY modes.
* Even though HSIC mode is a PHY-less mode, the reset
* line exists between the chips and can be modelled
* as a PHY device for reset control.
*/
for (i = 0; i < omap->nports; i++) {
- if (!omap->phy[i])
+ if (!omap->phy[i] ||
+ pdata->port_mode[i] == OMAP_EHCI_PORT_MODE_PHY)
continue;
usb_phy_init(omap->phy[i]);
--
1.7.4.1
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
