I'm trying to configure an Aircard 850 to run on my Thinkpad Z61m which runs
Debian (kernel 2.6.18-3-686). I followed the directions here:
http://mycusthelp.com/sierrawireless/supportkbitem.asp?sSessionID=&Inc=6704&sFilA=FAQ%20Category&sFilB=Products&sFilC=&KEY=linux
but the card is not assigned a
", 0xd85f6206, 0x42a2c018),
Thanks Peter, unfortunately this didn't seem to help. Any other ideas? I
tried adding the same line to the 2.6.21 source and rebooting to that
kernel but no dice either.
- Josh
___
Linux PCMCIA reimplementation list
http://lists.infradead.org/mailman/listinfo/linux-pcmcia
gt;
> Could you send the full dmesg after insertion?
pccard: PCMCIA card inserted into slot 0
pcmcia: registering new device pcmcia0.0
Thanks again,
- Josh
___
Linux PCMCIA reimplementation list
http://lists.infradead.org/mailman/listinfo/linux-pcmcia
8 0x48ff. Add this to /etc/pcmcia/config.opts file.
The CIS file is binary, how do I figure out the io port range assigned?
- Josh
___
Linux PCMCIA reimplementation list
http://lists.infradead.org/mailman/listinfo/linux-pcmcia
On Tue, 19 Jun 2007, rukhsana ansari wrote:
> Josh,
>
> I used the dump_cis utility to get the io port range. The mail attachment
> contains it. You can check out its help at:
> http://pcmcia-cs.sourceforge.net/man/dump_cis.8.html
Thanks. I got the following output:
lab001:~# dum
dial on /dev/ttyS0? Is
that connected to the errors I see when starting cardmgr?
Thanks,
Josh
___
Linux PCMCIA reimplementation list
http://lists.infradead.org/mailman/listinfo/linux-pcmcia
o /dev/ttyS0.
As I mentioned I tried running minicom /dev/ttyS0 and typing AT but did
not see the text showup.
- Josh
___
Linux PCMCIA reimplementation list
http://lists.infradead.org/mailman/listinfo/linux-pcmcia
ket-startup. I had the same results. I can try
2.6.21.5, if you think that will make a difference. Do you think this is
caused by a problem with Debian kernels?
- Josh
>
>
> //Peter
>
> ___
> Linux PCMCIA reimplementation
As mentioned previously, I'm trying to get an Aircard 850 running under
Debian 2.6.21-1. I noticed that when I insert the card I see the
following in udevmonitor:
lab001:~# udevmonitor
udevmonitor prints the received event from the kernel [UEVENT]
and the event which udev sends out after rule pro
irq that setserial was showing) and added the
IO port range listed in /proc/ioports for pcmcia_socket0 to
/etc/pcmcia/config.opts. After rebooting the machine the UART in setserial
was automatically set and I was able to access the card via minicom.
When
information that might be helpful?
- Josh
___
Linux PCMCIA reimplementation list
http://lists.infradead.org/mailman/listinfo/linux-pcmcia
11 matches
Mail list logo