Hi Ulf,
> From: Amitkumar Karwar [mailto:akar...@marvell.com]
> Sent: Thursday, June 16, 2016 2:53 PM
> To: linux-wireless@vger.kernel.org
> Cc: Nishant Sarmukadam; Wei-Ning Huang; linux-...@vger.kernel.org;
> Cathy Luo; Xinming Hu; Amitkumar Karwar
> Subject: [PATCH v4 1/2] mmc: API for accessing
On 21-12-2016 23:23, Ozgur Karatas wrote:
>
> The patch fixed to struct uses in reg.c, I think doesn't need to be use to
> "struct".
> There is dataype not have to logical link and each is different definitons.
>
> I'm undecided on this patch. I compiled and didn't to errors.
There must be s
Hello everyone,
I would like to modify the retry threshold for dropping a packet using
mesh mode. I tried with iw
iw phy set retry [short ] [long ]
with short and long limits equal to 10 first and later 5, but I couldn't
tell any effect. I'm checking by adding a printk in `status.c` and
man
Hi Dave,
before the holidays a really small pull request for 4.10. I just want to
have the regressions in rtlwifi and ath9k fixed quickly so I send this
earlier than I normally would.
Please let me know if there are any problems.
Kalle
The following changes since commit ad688cdbb076833ba17fc655
Hi Christian,
once again sorry for the delay
>
> On Monday, December 19, 2016 10:19:57 PM CET Mohammed Shafi Shajakhan wrote:
> > On Sat, Dec 17, 2016 at 06:46:34PM +0100, Christian Lamparter wrote:
> > > The 10.4 firmware adds extended peer information to the
> > > firmware's statistics payload
From: Kalle Valo
Date: Thu, 22 Dec 2016 17:11:27 +0200
> before the holidays a really small pull request for 4.10. I just want to
> have the regressions in rtlwifi and ath9k fixed quickly so I send this
> earlier than I normally would.
>
> Please let me know if there are any problems.
Pulled, t
Hello Shafi,
On Thursday, December 22, 2016 9:18:01 PM CET Mohammed Shafi Shajakhan wrote:
> > On Monday, December 19, 2016 10:19:57 PM CET Mohammed Shafi Shajakhan wrote:
> > > On Sat, Dec 17, 2016 at 06:46:34PM +0100, Christian Lamparter wrote:
> > > > The 10.4 firmware adds extended peer inform
On Mon, Dec 19, 2016 at 5:23 PM, Geoff Lansberry wrote:
> I can make that change, however, I worry that it may be a bit
> misleading, since there are only two supported clock frequencies, but
> a number like that to me implies that it could be set to any number
> you want. I'm new at this, and s
Am 22.12.2016 um 13:34 schrieb Ferran Quer i Guerrero:
> Hello everyone,
>
> I would like to modify the retry threshold for dropping a packet using
> mesh mode. I tried with iw
>
> iw phy set retry [short ] [long ]
>
> with short and long limits equal to 10 first and later 5, but I couldn't
From: Ryan Hsu
The txpower is being recalculated when adding interface to make sure
txpower won't overshoot the spec, and when removing the interface,
the txpower should again to be recalculated to restore the correct value
from the active interface list.
Following is one of the scenario
On Wed, Dec 21, 2016 at 11:18:32PM -0500, Geoff Lansberry wrote:
> The TRF7970A has configuration options to support hardware designs
> which use a 27.12MHz clock. This commit adds a device tree option
> 'clock-frequency' to support configuring the this chip for default
> 13.56MHz clock or the opti
On Wed, Dec 21, 2016 at 11:18:33PM -0500, Geoff Lansberry wrote:
> The TRF7970A has configuration options for supporting hardware designs
> with 1.8 Volt or 3.3 Volt IO. This commit adds a device tree option,
> using a fixed regulator binding, for setting the io voltage to match
> the hardware co
From: Ryan Hsu
With command to get board_id from otp, in the case of following
boot get otp board id result 0x board_id 0 chip_id 0
boot using board name 'bus=pci,bmi-chip-id=0,bmi-board-id=0"
...
failed to fetch board data for bus=pci,bmi-chip-id=0,bmi-board-id=0 from
ath10k/Q
From: Colin Ian King
Trivial fixes to spelling mistake "Ivalid" to "Invalid" in
brcmf_err error messages.
Signed-off-by: Colin Ian King
---
drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/net/wireless/b
On Wednesday 21 December 2016 08:51 PM, Matteo Grandi wrote:
> Hi all again, just an update to the previous message:
>
> looking at iw list I found this situation:
>
> Frequencies:
> * 5180 MHz [36] (20.0 dBm)
> * 5200 MHz [40] (20.0 dBm)
> * 5220 MHz
Это копия сообщения, которое вы отправили Контакты через ООО Авалон
Это письмо отправлено с сайта http://avalon-tuapse.ru/ от:
KoLMissotrolo
Our реts can't sреаk for thеmsеlvеs, but yоu саn tell whеn yоur fаmily friеnd
is hurting. Pеrhарs they'rе hаving a bit of a difficult timе getting uр aftе
16 matches
Mail list logo