Just a follow up in case someone has an Atrix Laptop that they want to use
with a bbb and machinekit.
I was able to get it to work with some caveats.
It seems that my initial confusion was cause by a bad SD card. After I got
that resolved I was able to boot up machinekit.
There is something a bit
Please keep replies on-list.
On 3/3/2017 11:46 AM, Chris Albertson wrote:
>> When loaded, the driver takes the command line arguments and builds a
>> task list in PRU memory to implement the desired function(s). This
>> list also contains any parameters and local storage required for each
>> "tas
I've built about 80% of a garage sized, tripodkins cable driven, pellet fed
3D printer for making statues.
If the BBGW's wifi worked, my steppers and the BBGW could be relocated to
the flying bit and all that would need to tether it would be a power cord.
USB wifi makes the BBB unstable due t
I am using BBG without WiFi and I am happy with them. They just don't
have HDMI output.
03/03/2017 09:35 AM, Daren Schwenke rašė:
The new image boots now if I recall correctly. The wifi chip doesn't
work though, so not all that useful atm and I grew tired of working on
it via serial.
The wifi
On 3/3/2017 10:22 AM, 'Marco Negrini' via Machinekit wrote:
> hi everyone,
> i am studying machinekit, in particular on the BeagleBone, i' ve found that
> in
> the CRAMPS.hal file it loads a file for the PRU called pru_generic.bin.
> for what i've been able to see, the pru now controls stepgen an
On 03/03/17 16:22, 'Marco Negrini' via
Machinekit wrote:
hi everyone,
i am studying machinekit, in particular on the BeagleBone,
i' ve found that in the CRAMPS.hal file it loads a file for
the PRU called pru_generic.bin.
for
hi everyone,
i am studying machinekit, in particular on the BeagleBone, i' ve found that
in the CRAMPS.hal file it loads a file for the PRU called pru_generic.bin.
for what i've been able to see, the pru now controls stepgen and pwm
generation.
is there a manual for this libraries for the PRU?
i
Hi all,
i am using machinekit ona beaglebone to control a 3dprinter, but sometimes
it stops reading the temperature of extruder and/or bed. Then it starts
heating too much.
I've tryed to look for the problem, but i didn't found anything...
has anyone already seen this problem? why does it happen?