Sorry for the misquote. Buying is fine for me, do you know when/where will
it available? (I am from Europe)
Il giorno lunedì 16 ottobre 2017 21:26:09 UTC+2, Daren Schwenke ha scritto:
>
> The mixing head was not open source. Everything else was. That was a
> misquote.
> At least it will not b
The mixing head was not open source. Everything else was. That was a
misquote.
At least it will not be until we can get to producing them ourselves, so
the cost/benefit analysis people will do will land on the side of 'just buy
it'.
We were trying to be totally self-funded to do so, but the ca
Nice printer!
Can I ask you a question about the Arcus-3d-M2, here?
I remember reading that you were trying to make the extruder as an open
source project, how is it going?
I would really like to use it for its speed!
Regards,
Marco Negrini
--
website: http://www.machinekit.io blog: http://b
Nice printer! just one thing: how does it go up and down?
Then, can I ask you a question about the Arcus-3d-M2, here?
I remember reading that you were trying to make the extruder as an open
source project, how is it going?
I would really like to use it for its speed!
Regards,
Marco Negrini
--
> On 12 Oct 2017, at 18:55, Daren Schwenke wrote:
>
> Featured on Hackaday, again. :)
>
>
> http://hackaday.com/2017/10/12/this-3d-cable-printer-remixes-the-delta/
>
> Go Machinekit!
Go Daren!
>
> Still need to build a tripodkins config with Machineface...
>
>> On Friday, October 6, 2
Featured on Hackaday, again. :)
http://hackaday.com/2017/10/12/this-3d-cable-printer-remixes-the-delta/
Go Machinekit!
Still need to build a tripodkins config with Machineface...
On Friday, October 6, 2017 at 5:10:35 PM UTC-4, Daren Schwenke wrote:
>
> Built this with the intent of running M