Because nail polish is a thin porous coating with no strength per se. Would
you trust it to seal a leak in a tire or a crack in a drinking glass?
If a tube is going to outgas around the glass/pin interface, no coating or
other treatment is going to prevent that leakage. The seal is either good
I would be curious as to the gas permeability of a layer of nitrocellulose
(nail polish). I imagine it may not be that good?
On Tue, Jan 17, 2023 at 8:00 AM Paul Andrews wrote:
> Why?
>
> On Friday, January 13, 2023 at 5:44:42 PM UTC-5 Terry S wrote:
>
>> I seriously doubt nail polish will
Why?
On Friday, January 13, 2023 at 5:44:42 PM UTC-5 Terry S wrote:
> I seriously doubt nail polish will prevent gas leaks at the pins.
>
> On Thursday, January 12, 2023 at 8:39:40 AM UTC-6 Paul Andrews wrote:
>
>> I've had one IN-18 (out of 6) outgas like this, and I've seen multiple
>>
I seriously doubt nail polish will prevent gas leaks at the pins.
On Thursday, January 12, 2023 at 8:39:40 AM UTC-6 Paul Andrews wrote:
> I've had one IN-18 (out of 6) outgas like this, and I've seen multiple
> reports of the same. Now I apply clear nail varnish to the joint between
> the
I dont remember seeing any posts about fake nixies. More likely, tubes sold
as NOS are actually used. I've even bought a few that were completely dead
because they were sold untested/as-is at a good price. I knew the risk, and
usually it's OK. Having a few spares is always good practice.
I can't remember.
It probably worked for a few years,
After the failure, it was put into the warehouse.
Now I'm arranging the warehouse, Thinking about to fix it.
BTW, does CCCP IN-14 exist fakes?
The markings on my IN-14 fall off very easily.
It falls off when touches water.
gregebert 在
I've had one IN-18 (out of 6) outgas like this, and I've seen multiple
reports of the same. Now I apply clear nail varnish to the joint between
the glass and the pin. I'm sure it depends how you socket them.
On Wednesday, January 11, 2023 at 5:07:00 PM UTC-5 gregebert wrote:
> It's always sad
It's always sad when a nixie tube dies. How long was it running ?
The only Soviet-era nixies I'm using are IN-18, and they are exceptionally
good tubes. Consider those for a future project. I have not had any fail
yet; my 14-tube clock has been running since 2015.
On Tuesday, January 10, 2023
Sad... so I need to replace it.
But luckily, I used the original plastic sleeves to make the sockets. (use
DIP IC socket pin)
I just need to replace the tube. ;-)
Thanks for everyone's explanation.
overdoingism Lab. 在 2023年1月10日 星期二晚上7:10:23 [UTC+8] 的信中寫道:
> Hello,
>
> I have a failure