Re: USB stick error message

2021-10-15 Thread Bob Bernstein
Thank you Michael, but I cannot justify taking up anymore of your valuable time on this problem. I only purchased my first USB stick a scant few years ago, and only then because my wife wanted to use one on her Mac. I've never felt a need to have one around, although I'm sure they're all kinds

Re: USB stick error message

2021-10-15 Thread Michael van Elst
poo...@ruptured-duck.com (Bob Bernstein) writes: ># installboot -v -o timeout=1 /dev/rsd1a /usr/mdec/bootxx_ffsv1 >File system: /dev/rsd1a >Primary bootstrap: /usr/mdec/bootxx_ffsv1 >Boot options:timeout 1, flags 0, speed 9600, ioaddr 0, >console pc >installboot: Writing

Re: USB stick error message

2021-10-14 Thread Bob Bernstein
On Thu, 14 Oct 2021, Michael van Elst wrote: Are you sure you started the 'a' partition at 63 like in the example ? I think the question is did I perform ALL the steps listed in that section of the wiki page? Just now, executing the last one, I ran into an error I did not see before:

Re: USB stick error message

2021-10-14 Thread Bob Bernstein
On Thu, 14 Oct 2021, Michael van Elst wrote: Are you sure you started the 'a' partition at 63 like in the example ? I "think" I did, but I wouldn't bet my life on it! All I can do is repeat the experiment, perhaps with a little bit (or a lot!) more attention to the details. Thank you.

Re: USB stick error message

2021-10-14 Thread Michael van Elst
poo...@ruptured-duck.com (Bob Bernstein) writes: >I followed the Netbsd-Wiki article "how to install netbsd from >an usb memory stick," specifically the section labeled "Make the >Memory Stick bootable" found here:

Re: USB stick error message

2021-10-13 Thread Bob Bernstein
On Wed, 13 Oct 2021, Michael van Elst wrote: fn: diskn 1: NetBSD Error 3 The message comes from the MBR bootcode and says that the PBR bootblock has an invalid signature which usually means it hasn't been written. Is that a defect that is susceptible of a remedy that would not be

Re: USB stick error message

2021-10-13 Thread Michael van Elst
poo...@ruptured-duck.com (Bob Bernstein) writes: >fn: diskn >1: NetBSD >Error 3 The message comes from the MBR bootcode and says that the PBR bootblock has an invalid signature which usually means it hasn't been written.

USB stick error message

2021-10-12 Thread Bob Bernstein
I put the USB stick that has been booting my NUC -- equipped with current 9.99.88 -- into my old eMachine, hit F12 when the eMachine logo appeared, and was presented a boot-device selector screen that correctly identified the stick. Choosing it I was soon at a halt with these three lines