Could you post this for me, I cannot seem to get this thing posting? Thanks, Installed mandrake linux 7.1 perfectly using Automode install, the X-Windows interface during the instal worked fine, it recognized all my hardware, but during the reboot progress it failed. I got something like, "Start1 Start2" then it hung. I forget the actual words, but it hangs on boot up and does nothing. Tried booting from floppy so I could run and check the lilo.conf, but I could not get the floppy boot to recognmize the CD-ROm during 'Recovery' mode. So I never got a prompt. I used to use RH 5.1, but I am NOT an expert user. My hardware: E-Machines Pentium II 333mhz 32 mb memory 2Gig HD Partition does include /temp /usr and swap drives CD-ROM IDE NEC Monitor Question: Do I need to re-run LILO or look at my LILO.conf? In auto install mode, I did not specify MBR or 1st drive as my boot method, does it matter which I use? I usually use my 1st drive. I also tried to install an old version of Redhat Linux, but it also hung on re-boot. The system works fine with Win98 and Win2000, which is how I polled the hardware to set up linux. I am NOT doing dual boot.m Thanks, Michael Michael Hatzakis, Jr MD Assistant Professor of Rehabilitation Medicine University of Washington Medical Center Medical Director, Inpatient and Cardiac Rehabilitation Programs Puget Sound Veterans Administration Health Care System [EMAIL PROTECTED] (206) 277-1792 (206) 764-2263 Fax On Sat, 19 Aug 2000, Samantha Lane wrote: > Hi, > I've gor a Brother 1040. Linux installed the HPIIP driver, which it > emulates, but I always get > the top 0.5 cm chopped off the page. Does anyone have a solution to > this? Will CUPS fix it do > you think? I have a funny feeling that the HPIIP has a different paper > path and can't print the > bottom 0.5 cm so the drive compensates for it. > > Samantha > > >