Hello folks, I have an WO2 mother board, with a Quantum 30 Gb ATA 66 (hda) with two windows partition and a second harddrive Seagate ATA 100 (hdb) with two mandrake system installed, MDK 7.2 (working fine, including Epson USB scanner, CDrwriter, DVD -with xine I could see splendid dvd-movies- cable modem, epson stylus 760 printer, avermedia tv....) and beta2 MDK 8.0 (with few problems now). I haven't had any problem but perhaps the ATA 100 is not optimized. MDK 7.2 and 8.0 beta1 and now beta2 installed both drivers without problems. Francisco Alcaraz Murcia (Spain) ----- Mensaje Original ----- Remitente: "Ton Truong" <[EMAIL PROTECTED]> Fecha: Viernes, Marzo 16, 2001 10:14 pm Asunto: RE: [newbie] Installation of Mandrake 7.2 on ATA 100 harddisc- I'Will WO2 onboard controller > > I dunno, but it should be: > > ide2=0x01f0,0x0400 ide3=0x0170,0x0380 > > Beware, this is from memory, not from fact as I don;t have an > IWill board. > > > Regards, > > > > -----Original Message----- > > From: [EMAIL PROTECTED] > > [mailto:[EMAIL PROTECTED]]On Behalf Of Stephen Liu > > Sent: Friday, March 16, 2001 4:05 AM > > To: [EMAIL PROTECTED] > > Subject: [newbie] Installation of Mandrake 7.2 on ATA 100 > > harddisc-I'Will WO2 onboard controller > > > > > > Hi all people, > > > > Re Installation of Mandrake 7.2 on ATA 100 hard disc > > > > I'Will WO2 onboard controller > > > > From MSWindows > Settings > Control Panel > System > Device > Manger > > > Storage Contoller > Resources, following data were found : > > > > a. Input/Output Range 01F0 - 01F7 > > b. Input/Output Range 03F6 - 03F6 > > c. Interrupt Request 14 > > d. Input/Output Range 0170 - 0177 > > e. Input/Output Range 0376 - 0376 > > f. Interrupt Request 15 > > g. Input/Output Range F000 - F000F > > > > Is it to make following changes : > > > > linux ide2 = 01F0-01F7, 03F8-03F8 ide3 = 0170-0177, 0378-0378 > > > > Whether the formula ide2=a, (b+2) ide3=c (d+2) are still > applicable ? > > > > Thanks in advance. > > > > B.R. > > Stephen > > > > > > > > > > > >