I would like to setup “port mirroring” … I would like to mirror network
specific packets going to a zone to another zone. What are some approaches I
can take to doing this?
Does ilbadm/ipfilter support this?
I haven’t used Crossbow in a while, so am trying to remember if there is
something in
When will the next OI beta release be out? I've been wanting the virtio block
support from the illumos kernel in OI.
Anil
___
OpenIndiana-discuss mailing list
OpenIndiana-discuss@openindiana.org
I am not able to run OI as a guest in SmartOS/KVM. Are there virtio drivers I
can install to get it to recognize the disks? Are there plans to integrate
official drivers into upstream?
Thanks,
Anil
___
OpenIndiana-discuss mailing list
Are there any improvements planned for OI/Illumos with being able to migrate a
zone from one system to another w/o having to detaching or doing some offline
cloning? (in a supported way)
I really wish something can be made to make this type of move easier.
The proper way is to 1) halt, 2)
, 2012, at 10:44 PM, Richard Elling wrote:
On Feb 25, 2012, at 8:49 PM, Anil Jangity wrote:
What I am really trying to do is, isolate the zone, but also at the same
time have it be able to talk the outside world. Going over the real link
means it would see all the wire traffic (broadcasts etc
properly, if at all?
On Feb 25, 2012, at 10:43 AM, James Carlson wrote:
On 2/24/12 8:06 PM, Anil Jangity wrote:
I tried to setup a etherstub and a vnic. I then tried to setup a bridge
between that and the physical interface, as follows:
LINKCLASS MTUSTATEBRIDGE OVER
I tried to setup a etherstub and a vnic. I then tried to setup a bridge between
that and the physical interface, as follows:
LINKCLASS MTUSTATEBRIDGE OVER
igb0phys 1500 up zbridge--
igb1phys 1500 up -- --
workswitch0
# ifconfig work0 plumb
ifconfig: cannot plumb work0: Interface already in use
global-zone#
So, I have to configure the interface outside the zone and not in the zone
itself? Why does it show unknown?
On Feb 24, 2012, at 5:06 PM, Anil Jangity wrote:
I tried to setup a etherstub and a vnic. I
I just upgraded from 134b to 151a2. It seems there is a r flag (rename) under
Obsolete column. So, if the package was renamed, why do I still see this under
old name? Is there a way to clear them?
I am guessing this might be because there are some packages that are dependent
on others, under