Hi guys,
Normally, when you access an Ethernet PHY through an MDIO bus, you specify a
5-bit PHY address that selects one of the PHYs attached to the bus, and a 5-bit
register address that addresses a register inside that PHY.
The ADM6996FC and ADM6996M switch chips occupy this full address
On 10 April 2011 12:09, Peter Lebbing pe...@digitalbrains.com wrote:
So, do you have any ideas on the best way to properly handle this PHY that
looks
like 32 PHYs?
Take a look at ar71xx, they define a (machine dependent) phy mask for
each eth that says at which phy addresses a device may
and of course the Pro uses a different switch, the AR8216.
David
On Sunday 10 April 2011, Jonas Gorski wrote:
On 10 April 2011 12:09, Peter Lebbing pe...@digitalbrains.com wrote:
So, do you have any ideas on the best way to properly handle this PHY
that looks like 32 PHYs?
Take a look at
On 10 April 2011 17:54, David Goodenough
david.goodeno...@linkchoose.co.uk wrote:
and of course the Pro uses a different switch, the AR8216.
Actually the AR8316 ;-). But similar to the ADM6996M/FC, the internal
switch registers are accessed through the MDIO interface by reading
and writing to
