I've created an odd footprint for a SMT Current Sense Resistor. Each L
shaped "pad" on the footprint consists of a pad and a copper fill attached
to it because I want the solder mask on the fill.
Anyways, when I run DRC I get a short circuit error between the fill of the
"pad" and the pad of the
It is a short. The resistance doesn't matter.
Ignore it. Same happens for scratchable connections.
One way is to have two connectors with the same number,
then a short is allowed. But then the nets are equalized.
Rene
--
Ing.Buero R.Tschaggelar - http://www.ibrtses.com
Tim Fifield wrote:
>
>
At 04:16 PM 11/19/01 -0400, Tim Fifield wrote:
>I've created an odd footprint for a SMT Current Sense Resistor. Each L
>shaped "pad" on the footprint consists of a pad and a copper fill attached
>to it because I want the solder mask on the fill.
>
>Anyways, when I run DRC I get a short circuit err
At 09:53 PM 11/19/01 +0100, Rene Tschaggelar wrote:
>It is a short. The resistance doesn't matter.
>Ignore it. Same happens for scratchable connections.
>One way is to have two connectors with the same number,
>then a short is allowed. But then the nets are equalized.
I do not advise ignoring any
On 04:16 PM 19/11/2001 -0400, Tim Fifield said:
>I've created an odd footprint for a SMT Current Sense Resistor. Each L
>shaped "pad" on the footprint consists of a pad and a copper fill attached
>to it because I want the solder mask on the fill.
>
>Anyways, when I run DRC I get a short circuit er
Thanks to all who replied to this thread!
Tim.
-Original Message-
From: Ian Wilson [mailto:[EMAIL PROTECTED]]
Sent: Monday, November 19, 2001 6:14 PM
To: Protel EDA Forum
Subject: Re: [PEDA] Short Circuit: Pad/Fill
On 04:16 PM 19/11/2001 -0400, Tim Fifield said:
>I've create
