On 23/01/14 19:30, Nikos Chantziaras wrote:
On 23/01/14 19:03, Alexander E. Patrakov wrote:
OK. The problem is that the card has a 6-channel Master control that
alsamixer converts into three controls, including Master Front that
confused us. Unfortunately, PulseAudio cannot handle such
Rex Dieter wrote:
Tanu Kaskinen wrote:
Good evening!
The first release candidate for 5.0 is now available.
Tarball fails to build for me (on fedora 20):
make[2]: *** No rule to make target `pulsecore/svolume.orc', needed by
`pulsecore/svolume-orc-gen.c'. Stop.
Looks like at least
On Fri, 2014-01-24 at 07:24 -0600, Rex Dieter wrote:
Rex Dieter wrote:
Tanu Kaskinen wrote:
Good evening!
The first release candidate for 5.0 is now available.
Tarball fails to build for me (on fedora 20):
make[2]: *** No rule to make target `pulsecore/svolume.orc', needed
HI,
I am running pulseaudio but somehow its not able to enumerate a sink.
Here PA is running as part of emulator , though it runs on the actual
system perfectly.
when i run paplay
paplay Side_Right.wav
sndfile: Bad parameter passed to function sf_command.
Failed to determine sample
Not having ORC_SOURCE defined results in different tarballs depending on
whether the dev issuing 'make dist' has orc support enabled or disabled.
Specifying ORC_SOURCE unconditionally addresses that, without causing
negative effects on users not having orc in the end.
---
orc.mak | 2 ++
Hello everyone!
I have an issue with Pulseaudio 4.0 and a bluetooth headset.
Whenever I change the profile from a2dp to hsp while a program is using the
microphone, pulseaudio aborts with the following message:
[pulseaudio] source.c: Assertion 'PA_SOURCE_IS_LINKED(s-state)' failed at
On Fri, 2014-01-24 at 21:45 +0100, Dominique Leuenberger wrote:
Not having ORC_SOURCE defined results in different tarballs depending on
whether the dev issuing 'make dist' has orc support enabled or disabled.
Specifying ORC_SOURCE unconditionally addresses that, without causing
negative
On Fri, 2014-01-24 at 15:51 +0200, Iskren Hadzhinedev wrote:
Hello everyone!
I have an issue with Pulseaudio 4.0 and a bluetooth headset.
Whenever I change the profile from a2dp to hsp while a program is using the
microphone, pulseaudio aborts with the following message:
[pulseaudio]
I have a Marmitek BoomBoom 540 bluetooth headset.
I connected it with the hsp profile and setup the microphone to be the
preferred recording device in KDE sound settings. Then I switched the profile
to a2dp for high-quality audio. When the Bluetooth microphone is unavailable
KDE falls back to
