hi .
i recently bougth a Tait ts5040 alarm unit as i am wondering if anyone
has any schematics of this unit
and if anyone has did some test with a T800(crystal version)Rx and Tx
wit CTCSS ???
with regards ..
Joost,PE1RMN
PI3GOE,145,725MHZ
Group,
Thank you very much for the information. A few people contacted me
off list and of course, Eric's response helps tremendously.
Will start looking for someone, organization or individual, that may
be able to help or do the conversion on these units. Have 4 of them.
And another two meter
I'm interested in remotely monitoring the power/SWR at the repeater site and
having the ability to have a macro poll the device and report status over
the repeater output. I see that LDG makes a power meter with a voice output
that I could probably interface, but is there something designed more
Mike,
The LDG TW-2 talking power monitor appears to be ideally suited to your
application, since all you need is to provide switch closures to the unit
and then apply the audio output to the controller for transmission. If you
were to use a commercial forward/reverse power monitoring module from
Eric,
In a perfect world, I'd love to both hear specific values AND be alerted if
values drifted out-of-bounds. The idea of remote monitoring came about
because we have several users who swear 'the repeater is weak today', but
whenever I go check it, inevitably it's just fine. I'd love to be
Mike,
Oh, you've got one of those guys, too? He might be related to the fellow in
my area who thinks that increasing the power on his mobile radio will raise
the volume level on the 2m repeater- even if he is already full quieting!
He and his relatives always give loud and clear signal reports,
While trying to align a MASTRII , I discovered that my IFR1500 OCXO lost
the oven. (or so it seems). Prior to this, I noticed that the
frequency was 170Hz off and it could not be netted with the front
control. Then, I found it 10Khz off frequency at 450Mhz. Watching the
frequency of the
Hi Joe,
In past a friend of me give me 2 Cushman CE-4B service monitor and the 2
test-set have rouble with the 5MHz HSO. I have work every night on these
famous oscillators to find an open contact on the nichrome wire. To repair
the oven I remove one turn of the nichrome wire and retwist the
Mike Besemer (WM4B) wrote:
Eric,
In a perfect world, I’d love to both hear specific values AND be alerted
if values drifted out-of-bounds. The idea of remote monitoring came
about because we have several users who swear ‘the repeater is weak
today’, but whenever I go check it,
At 05:40 PM 12/16/07, you wrote:
Mike,
Oh, you've got one of those guys, too? He might be related to the fellow in
my area who thinks that increasing the power on his mobile radio will raise
the volume level on the 2m repeater- even if he is already full quieting!
Like the local guy that has a
10 matches
Mail list logo