Re: [Repeater-Builder] Adapting ctcss decoders to maxon pm150

www.kerinvalecomaudio.com.au ---Original Message--- From: Don Crutcher Date: 3/03/2010 4:21:09 PM To: Repeater-Builder@yahoogroups.com Subject: Re: [Repeater-Builder] Adapting ctcss decoders to maxon pm150 Hello again Ian I've

Re: [Repeater-Builder] Adapting ctcss decoders to maxon pm150

9922574 Fx 0749922767 www.kerinvalecomaudio.com.au ---Original Message--- From: Don Crutcher Date: 3/03/2010 3:04:49 PM To: Repeater-Builder@yahoogroups.com Subject: Re: [Repeater-Builder] Adapting ctcss decoders to maxon pm150

Re: [Repeater-Builder] Adapting ctcss decoders to maxon pm150

Hello Ian IF your repeater is a UHF and the CTCSS decoder has a 5 MHz crystal oscillator, it will mix with the transmitter and give a signal at the receiver frequency 5 MHz lower (in Australia RX 433-435 TX 438-440 MHz) This a is a common occurrence with UHF Philips FM-828's. The fix is to use a

Re: [Repeater-Builder] remote head ?

Hello David On the remote head there are usually 2 cables, 1 red and 1 black. The Black is the remote mike, volume, mute, on/off, the Red is the channel change. Plug the Red 10 pin WIST plug into the Red socket and the Black into the Black socket. Set the channel switch on the remote to the cha

Re: [Repeater-Builder] schematics T856/05

Hello Joost Try the Tait web page of obsolete equipment. http://www.taitworld.com/technical/index.cfm/4,0,76,46,html Regards Don vk2zcz - Original Message - From: pe1rmn To: Repeater-Builder@yahoogroups.com Sent: Sunday, September 21, 2008 8:43 PM Subject: [Repeater-Builder

Re: [Repeater-Builder] Philips FM814 circuits

Hello Stef Does your handbook have a Buff or Blue cover, I have both, my Blue cover HB is dated 1985 Issue 2. The PCB numbers are for the blank board and not the made up board part number, just to be difficult. Looking at the Receiver layout in my Blue HB, I can see the PCB number (backwards

Re: [Repeater-Builder] Mitrek Reedless PL Board

- Original Message - From: Eric Grabowski To: Repeater-Builder@yahoogroups.com Sent: Sunday, December 30, 2007 10:10 PM Subject: [Repeater-Builder] Mitrek Reedless PL Board Does anyone know for certain whether the Mitrek HLN4181A reedless PL board can be used for encode

Re: [Repeater-Builder] Happy Holidays

- Original Message - From: Don To: Repeater-Builder@yahoogroups.com Sent: Tuesday, December 25, 2007 7:55 AM Subject: [Repeater-Builder] Happy Holidays I would at this time like to Wish all Members Families and Friends the Best wishes For a Wonderful Holiday Season a