At 09:04 AM 12/31/2003 -0500, you wrote:
>Go with the Socket and Vise method. I drill out some of the bushing material
>first also. Makes it easier to push out.
"Installation is the reverse of disassembly", eh?
:-)
Doug Braun
'72 Spit
*** http://www.team.net/the-local***
*** unsubsc
Message-
From: Nolan Penney [mailto:[EMAIL PROTECTED]
Sent: Wednesday, December 31, 2003 7:47 AM
To: [EMAIL PROTECTED]; [EMAIL PROTECTED];
[EMAIL PROTECTED]
Subject: Re: Rubber Bushing Removal
Vice and two sockets.
Use one socket that's larger then the bushing that the metal of the a-arm
can
If you can't push them out using a large vise, you can either drill them out or
take them to a machine shop, go next door for coffee and donuts and write a
check. I have done it both ways but I prefer the latter. Grease the new ones with
anti seize compound before you press them in.
Dave
>Any
Dan,
I was successfull in drilling a number of small holes in the rubber
and then pushing it out.
Doug
-Original Message-
Date: Wed, 31 Dec 2003 06:33:27 -0500
From: "Daniel Parrott" <[EMAIL PROTECTED]>
Subject: Rubber Bushing Removal
Any advice on the removal of rubber bushing from t
Go with the Socket and Vise method. I drill out some of the bushing material
first also. Makes it easier to push out.
- Original Message -
From: "Daniel Parrott" <[EMAIL PROTECTED]>
To: "Spitlist" <[EMAIL PROTECTED]>; "NASS" <[EMAIL PROTECTED]>
Sent: Wednesday, December 31, 2003 6:33 AM
Did mine in less than it takes to open a beer.
Small Propane torch, burn them out. Get it good and hot, push with a piece
of pipe.
-Original Message-
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]
On Behalf Of Daniel Parrott
Sent: Wednesday, December 31, 2003 6:33 AM
To: Spitlist; NASS
Vice and two sockets.
Use one socket that's larger then the bushing that the metal of the a-arm can rest
against.
Use a second socket that's smaller then the metal hole the bushing is in. Place it
against the rubber of the bushing.
Place this in a vice, and screw it down, pressing the smaller
A short length of pipe with the ID greater than the bushing, but an OD
That can be forced against the A-Arm itself, an old valve tappet or
Similar that is slightly smaller than the bushing, and a vise
With wide enough jaws to put the three together. The vise will
Press the tappet against the bushi