Greetings all,
After a long vacation, a sysadmin quitting, and another being hired, I am
finally back to my WCCP issue.
I have gotten a lot of very helpful advice from several on this list, and I
think I am pretty close to getting this thing running. Any suggestions or
comments are most
On Fri, 17 Jun 2005, Sturgis, Grant wrote:
My Cisco switch is still not showing the web-cache. How do I know if /
when squid is reporting to the switch? Anything other a packet trace to
check this?
Have you configured the WCCP router address in your squid.conf?
Regards
Henrik
Greetings List,
I am attempting to set up WCCP with a Cisco Cat 6506 and Squid.
squid-2.5.STABLE9-1.FC3.6
Fedora Core release 3 (Heidelberg)
2.6.11-1.27_FC3
I have followed the instructions from this article:
http://www.linux-mag.com/content/view/1957/2303/
Which basically boils down to:
--Original Mail--
From: Sturgis, Grant [EMAIL PROTECTED]
I didn't recompile squid from source, but simply used the FC3 RPM. Does
anyone know if that package is compiled with the
--enable-linux-netfilter and --enable-wccp options? Can you tell how to
check?
---
Did you compile
Phalen [mailto:[EMAIL PROTECTED]
Sent: Friday, June 17, 2005 11:42 AM
To: Sturgis, Grant; squid-users@squid-cache.org
Subject: Re: [squid-users] WCCP Setup
--Original Mail--
From: Sturgis, Grant [EMAIL PROTECTED]
I didn't recompile squid from source, but simply used the FC3
RPM
, Grant
Sent: Friday, June 17, 2005 11:54 AM
To: Scott Phalen; squid-users@squid-cache.org
Subject: RE: [squid-users] WCCP Setup
A-ha! No --enable-wccp, that's gonna be a problem. I will recompile.
As for the kernel module, no I didn't. In the article they
say that you just need
Grant:
Now that your RPM woes are a thing of the past...
BTW: about the wccpv2: patching the SRPM build tree with the visolve
wccp v2 patch requires running config twice -once to patch the tree and
again when the rpmbuild process runs. This generates errors at the end
of the rpm build process.
