Hello Bob and Jackie,
So glad to know you are alive and safe, so sad to realize your losses.
My heart is with you and I pray you will find the strength to carry on
and make a new life for yourselves.
All the best, John Coughran, 310-318-1547, 1525-A Artesia Blvd,
Manhattan Beach, CA 90266-716
I managed to find some RC car bearings at Tower Hobbies -- towerhobby.com
--that I think should work out ok for a roller stand. They are 8mm x 16mm.
The stock # is LDX140. The cost is $16.99 for 10 bearings. They also sell
a set of two bearings for $3.99.
Don
__
Hello Wojtek,
Please don't stop writing! It's always good to get some new people
involved in the list. And, if we don't know the answer to your
questions, we probably do know where to go to find out!
(or, we can always make something up from our imaginations!) Keep
reading, but always let us know w
I purchased a new Micro-Mark 7x12 lathe with lots of accessories about 2
years ago and have not had the time or energy to put it to good use in my SS
live steam hobby. I have only used it to practice on some brass and aluminum
stock. I will probably put it on Ebay soon, but if anyone is interested
Thanks a lot for your info. Now I feel like switching to reading rather
than writing.
Regards,
Wojtek
Keith Taylor wrote:
Harry & Steve,
So far, nobody has told Royce WHY the threads are
"grabbing"
Actually, Tony Dixon pointed this out in his first address of my question.
And my subsequent attempt was much more successful, but not completely.
Maybe this PM I'll achieve success.
Thanks for
Anthony Dixon wrote:
Sounds more like a split button die being used in the fully open
position
would not this cut the largest od thread ? Anything more "closed"
would cut a smaller od thread, I am assuming.
and not pre-adjusted adjusted down to optimum threading diameter, or
incorrect