Nice collection of articles they have there... lots of fun stuff if you
navigate up a directory or two and look around.
I have a synthesizer that uses an LT1016 comparator to square up the 10.7
MHz signal coming out of a post-DDS crystal filter, prior to driving the
reference pin of an Analog Devi
Interesting paper. I agree that for nanosecond timing applications then
antenna cable and matching are important. However, for frequency sync
applications and non-critical timing, then the effects of the 75 vs. 50 ohm
cable will not be noticeable.
Rob K
-Original Message-
From: [EMAIL PR
Rob Kimberley wrote:
> Interesting paper. I agree that for nanosecond timing applications then
> antenna cable and matching are important. However, for frequency sync
> applications and non-critical timing, then the effects of the 75 vs. 50 ohm
> cable will not be noticeable.
>
> Rob K
>
>
>>>
Guys,
I need a little help. I have an astronomer in Colombia who needs
replacement VP for an HP58503A. Can you tell me if an old 6 channel
receiver will work, or should I send him an 8 channel VP that supports
both 6 and 8 channel messages just to make sure it will work in his
system?
Thanks,
Is this link correct? I don't see refrences to antenna cables?
>From: Dr Bruce Griffiths <[EMAIL PROTECTED]>
>Reply-To: Discussion of precise time and frequency
>measurement
>To: Discussion of precise time and frequency measurement
>
>Subject: [time-nuts] Importance of matching antenna cable fo
Oops, didn't mean to send this to the group, sorry.
REM
Believe it or not, my internet connection died after sending the previous
msg in error but before I could send this apology. Internet connection just
now repaired (out for 11 hours).
-Original Message-
From: [EMAIL PROTECTED] [ma
Hi Steve,
Correct link was posted later by Bruce Griffiths
>> http://tf.nist.gov/timefreq/general/pdf/1384.pdf
Hope all OK with you and yours.
Rob Kimberley
-Original Message-
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On
Behalf Of Steve1 Baillargeon
Sent: 07 February 2007 16:
Steve1 Baillargeon wrote:
> Is this link correct? I don't see refrences to antenna cables?
>
>
No a slight typo should have been
http://tf.nist.gov/timefreq/general/pdf/1384.pdf
Bruce
___
time-nuts mailing list
time-nuts@febo.com
https://www.febo.c
Thanks,
Very interesting artical, it will take some time to digest.
>From: Dr Bruce Griffiths <[EMAIL PROTECTED]>
>Reply-To: Discussion of precise time and frequency
>measurement
>To: Discussion of precise time and frequency measurement
>
>Subject: Re: [time-nuts] Importance of matching ant
I put a 8 channel Oncore VP in a Z3801A. I had to tell the receiver to
be a 6 channel unit for it to work properly. The 8 channel unit
appeared to be a slight bit more receive sensitive . I also noted that
compared to the older 6 channel receiver, the 8 channel unit worked when
the older uni
10 matches
Mail list logo