Thank you John, If I test as you mention I will share the results.
Regards,
Edgardo Molina
Dirección IPTEL
www.iptel.net.mx
T : 55 55 55202444
M : 04455 10045822
Piensa en Bits SA de CV
Información anexa:
CONFIDENCIALIDAD DE INFORMACION
Este mensaje tiene carácter confidencial. Si us
I suspect it will work fine; worst case might be that you add a 3dB
attenuator, but I doubt you'll need it. I would test, if you can, to
see whether the output jitter varies between the full input level and
something that's closer to 1-2V p-p.
John
On 11/13/2012 9:52 PM, Edgardo Molina
Dear Bruce,
Thank you. I will order a unit and do my testing. You have a nice evening.
Regards,
Edgardo Molina
Dirección IPTEL
www.iptel.net.mx
T : 55 55 55202444
M : 04455 10045822
Piensa en Bits SA de CV
Información anexa:
CONFIDENCIALIDAD DE INFORMACION
Este mensaje tiene carácte
That should be OK connected directly to the input as the resultant
reverse bias on the switching transistor base-emitter junctions is well
within the specified limits
One can check this both by simulating the performance and by actual
measurement with a scope.
Bruce
Edgardo Molina wrote:
De
Dear John,
Your response is welcome. My square signal input is 3.3V and 50% duty cycle.
Low end 0.5V, High end 2.7V.
Will I be able to make it without the bypass? Or should I start warming the
soldering station?
Thanks!
Edgardo Molina
Dirección IPTEL
www.iptel.net.mx
T : 55 55 55202444
M
Hello Edgardo --
The T2-Mini uses a wide-range input circuit based on one that Wenzel published
with some modifications. It works with a square wave input (I've done some
limited testing) but I can't verify whether the input amplitude range will
extend as far on either the low or the high side
Dear Bruce,
Thank you for your kind reply. I think I will get a couple of these nice toys
to play a little bit with them.
Regards,
Edgardo Molina
Dirección IPTEL
www.iptel.net.mx
T : 55 55 55202444
M : 04455 10045822
Piensa en Bits SA de CV
Información anexa:
CONFIDENCIALIDAD DE IN
A 50% duty cycle square wave with an amplitude < 5V pp should be OK.
Bruce
Edgardo Molina wrote:
Dear Group,
Does anybody know is the TAPR TADD-2 Mini works with input signals with square
wave geometry? Or Sine wave only?
Thank you.
Regards,
Edgardo Molina
Dirección IPTEL
www.iptel.net.
Dear Group,
Does anybody know is the TAPR TADD-2 Mini works with input signals with square
wave geometry? Or Sine wave only?
Thank you.
Regards,
Edgardo Molina
Dirección IPTEL
www.iptel.net.mx
T : 55 55 55202444
M : 04455 10045822
Piensa en Bits SA de CV
Información anexa:
CONFIDE