Are you still using devfs?
Ernie
> -Original Message-
> From: M Taha Masood [mailto:[EMAIL PROTECTED]
> Sent: Thursday, August 11, 2005 7:49 PM
> To: Ernie Fontes; user-mode-linux-user@lists.sourceforge.net
> Subject: [uml-user] ile: unable to allocate pty/tty pair
&g
I had a similar problem.
Here's how I fixed it:
1) Boot your UML with this option added on the command line: init=/bin/sh
2) That should allow you to poke around in /dev. Check for terminals (eg.
tty0, tty1, tty/0, tty/1).
3) If there are none, and if you are using DevFS - which I suspect you are
[uml-user] problems getting started with User mode linux
>
> Start with the guest. The host isn't nearly as critical.
>
> Tony
>
>
> -Original Message-
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED] On Behalf Of M
> Taha Masood
> Sent: We
I recently had similar problems setting up UML.
You need to download a recent vanilla (unmodified) kernel from kernel.org.
(eg. 2.6.12)
Then patch it with the corresponding patch from
http://www.user-mode-linux.org/~blaisorblade
The instructions on that site should guide you through patching and
b
> Blaisorblade wrote:
> On Thursday 04 August 2005 17:36, Ruaidhri Power wrote:
> > On Thu, Aug 04, 2005 at 11:06:19AM -0400, Ernie Fontes wrote:
> > > devfs: 2004-01-31 Richard Gooch ([EMAIL PROTECTED])
> > > devfs: devfs_debug: 0x0
> > > devfs: boot_options
).
Slackware loads fine, but the red hat 7.2-full filesystem hangs while booting.
I am still very new to linux and user-mode-linux, so if you
would like to see any other log files, etc., please ask and I’ll try to
get them.
Below is the output of booting Redhat 7.2 with uml.
Ernie Fontes
Blaisorblade wrote:
> Also, make sure you compiled in UBD device support, and the support for
> the filesystem used by that image.
Thanks, I recompiled and made sure to check those options - now it's
working.
Thanks again for helping out a newbie to all of this.
E
on the website – to no avail! It still
segfaults.
I’ve attached the output from “strace linux”
on the bottom in hopes that it might help.
Any ideas on how I can get UML to run?
Ernie Fontes
[EMAIL PROTECTED] ernie]# strace linux
execve("/usr/bin/linux", ["linux"],
