[USRP-users] Use most of the ddr3 space in x310

Hello everyone , I want to load a file using the replay block that will consume almost all the space of the ddr3 on the device . I saw that replay block has a address range of 32mib which is not enough at all . How can i change the space address of the replay block and what is the max size i can p

[USRP-users] CAN YOU HELP ME OUT?

GOOD DAY.   URGENT - HELP ME DISTRIBUTE MY $12 MILLION TO HUMANITARIAN.   THIS MAIL MIGHT COME TO YOU AS A SURPRISE AND THE TEMPTATION TO IGNORE IT AS UNSERIOUS COULD COME INTO YOUR MIND BUT PLEASE CONSIDER IT A DIVINE WISH AND ACCEPT IT WITH A DEEP SENSE OF HUMILITY. I

Re: [USRP-users] X310 scheduled issue_stream_cmd()

Richard, I believe what you're looking for is the depth of the command queue. For the X310, this FIFO has a depth of 16. Any command that you issue to the X310 that has a command time set will be held in this FIFO until the radio's time matches the command time, at which point the command is execu

[USRP-users] Supported ethernet controllers : X300 and UBX

Hi There,   Good morning. As I could see in the documentation, Ettus recommends "X520 (Ethernet Controller)" at PC/host side. Is this a must?    We are planning to use X552 Ethernet Controller and I am wondering will it cause any issue. Can you please let me know what are the Ethernet Controller

Re: [USRP-users] Supported ethernet controllers : X300 and UBX

Santosh, That card should be fine for streaming, that controller just hasn't been explicitly tested as far as I know. Are you planning on using DPDK? Sam Reiter On Wed, Jan 15, 2020 at 12:26 PM voonna santosh via USRP-users < usrp-users@lists.ettus.com> wrote: > Hi There, >Good morning. As

Re: [USRP-users] X310 scheduled issue_stream_cmd()

Sam, Thank you for the help. Is there somewhere where the command queue depth is documented? Also is the same command queue used for both commands scheduled from rx_streamer and those scheduled with set_start_time()? Thank you, Richard From: Sam Reiter Se

Re: [USRP-users] Supported ethernet controllers : X300 and U

Please see my comments inline: That card should be fine for streaming, that controller just hasn't been explicitly tested as far as I know. [SV]: I am TXing data at 50MHz (not for rx) with one channel. Are there any other ethernet controllers rested? Are you planning on using DPDK?[SV]: NO (as I

Re: [USRP-users] Benchmarking set_tx_freq and set_rx_freq on X310, B210 and N200

Hi Marcus, Thanks for the inputs. I'll look into these. Thanks, Amrit On Mon, Jan 13, 2020 at 11:50 PM Marcus D. Leech via USRP-users < usrp-users@lists.ettus.com> wrote: > On 01/13/2020 05:26 AM, Amrit Pal Singh via USRP-users wrote: > > Hi All, > > I am benchmarking the following commands on