After power-cycling your cisco, send a break signal (not the Ctrl-C, the physical one). It is done by pressing ~ (tilde) followed by # (sharp) in tip. If you're using windows ntor w2k (and probably xp), you'll have to find a windows 9x workstation: its hyperterminal can send break signals (Ctrl-F5 or Ctrl-Break, I don't remember).
You have to send this break signal at the right time and you'll get a prompt from where you can reset the configuration. ----- Original Message ----- From: "Michael Desrosiers" <[EMAIL PROTECTED]> Date: Sunday, December 16, 2001 4:50 am Subject: cisco 2513 router > Hello all, > > I just received a cisco 2513 router w/16 Meg of Flash that I > purchased on > ebay. The problem seems to be I cannot reset the enable password > to redo > the configuration. I have found some documentation on cisco's > site in > reference to resetting the config register to 0x142, but I cannot > get rommon > to get back to a prompt to reset it. Any ideas would be greatly > appreciated8:( > > Thanks > Mike > >
