Please remove me from this mailing list. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Florin Sent: October 18, 2004 8:44 AM To: [EMAIL PROTECTED] Subject: Re: [Security Firewall] ipsec
"fifo55" <[EMAIL PROTECTED]> writes: > > > > > ipsec will not stop your masq ... this has nothing to do with > > the masq ... > > Hi, > > Well, ... I don't know why,... When I install the MNF2, (english & french), > In setup eth1 is "local" with "local ip" (192.168.x.x)... Then I restart > 1rst time... Always I have the ipsec wrong in startup, and squid wrong in > startup... It works fine here. Maybe you don't configure correctly your network during the install or maybe there is something else. I have tested here and it works without a problem. > Then I must do a shorewall clear to connect from another computer to > configure the firewall ... And when it restart the shorewall with the "new > config",.. It's "broken" again,.. I must do again a shorewall clear... And > again, ... it means you didn't configure correctly your network. Make sure you associate the right zones to the right NICs. > Another problem : when I let the gui configure the ppp0, the status in the > gui "network" is ping:xx,xmsec,... When I make the dyn. NAT ... The status > is down, (no ping... ) but the connection is ok... ? What's wrong ? I don't > change any rule ! Just put eth1 througt ppp0 (eth0 -> internet ) ! you need a rule in order to allow the ping from fw to the address specified for ping. > If you need more explanations... Tell me please what kind of message and > where I can found it... > -- Florin http://www.mandrakesoft.com http://people.mandrakesoft.com/~florin/
____________________________________________________ Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com Join the Club : http://www.mandrakeclub.com ____________________________________________________
