well, I'm not an expert but is basically like this: let's say u have: eth0 - first nic eth1 - second nic
So you CHOOSE which nic you get the cable from CISCO to that chosen nic. Then IP public u assign to this, and it will be WAN address. Second nic you give for example an address in this range: 192.168.*.* This can be used for LAN. So in here you plug cable that goes after to your INTERNAL SWITCH so you can give access to your internal LAN. On every station on your internal LAN you must declare the second nic 192.168.*.* that you choose before to be the GATEWAY for this stations. Then of course you put DNS from the ISP that gives you internet (wan access). In MNF you can find the section to declare the: ZONES - for example NET means internet or WAN place, LOCAL means internal LAN INTERFACES - declare WHICH eth* you assign to which ZONE RULES - here comes the real rules for your access by the MNF Then of course there is a section that tells you to use NAT (for example) so you can get the 'transparency' you wish and so connect from LAN stations to internet and viceversa. However Florin, is the BEST advisor in this, since he takes care of MNF and established this very forum. hope it was of some help 2 u my idea Pe 18 Feb 2005, la 09:53, Massimo Caranchini <[EMAIL PROTECTED]> a scris: >Hi all, > >I have only 1 Public IP that is assigned to the router (Cisco SOHO 77) > >How can i configure MNF with two nic ? > >What kind of address can i use for the wan nic ? >How can i configure the router to be "transparent" ? And what "internal" >address to assign to the router ? > >Many thanks in advance. > >Massimo Caranchini > >
____________________________________________________ Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com Join the Club : http://www.mandrakeclub.com ____________________________________________________
