Greetings,

I had exactly the same problem when I first tried to run it also on a Linux 
computer. The same error. That’s because I was using the binaries I had 
downloaded from the website. What I did was recompile Seisan from the source 
and it worked. Perhaps there is a more elegant solution, but that worked for me 
and it wasn’t that difficult.

Hope it helps.

Cheers,


Emanuel Antunes

Integrated Master Degree (MSc) in Physics Engineering
M.Sc. Thesis - Seismology Laboratory 
Instituto Superior Técnico (IST) - Lisbon Technical University (UTL)


On 2013/02/05, at 20:57, Carpenter, Seth wrote:

> Hi, I am trying to set up SEISAN v9.1 on a 64-bit LINUX computer.  When I try 
> to locate an event, either from within eev or on the command line, I get the 
> following error:
> At line 1635 of file tau.for (unit = 22, file = 
> '/home/seismic/SEISAN/DAT/IASP91_linux.HED')
> Fortran runtime error: End of file
>  
> Does anyone have experience with or insight on this error?
>  
> Also, the event I am working with is local, and I have an ‘S’ in the header 
> line which should force Hypocenter to use the header-line epicenter as the 
> starting location layered model in STATION0.HYP because no stations are more 
> than TEST(57) from this location.  So, I’m not sure why Hypocenter is trying 
> to use the IASP91 tables.  Any ideas?
>  
> I’ve attached the Sfile, STATION0.HYP, and make’s output from my build 
> (make.out) in case they are helpful.
>  
> Thanks!
> Seth
> =============================================================
> N. Seth Carpenter
> Seismologist
> Kentucky Geological Survey
> 228 MMRB, University of Kentucky
> Lexington, Kentucky 40506-0107
> (859) 323-0563
> [email protected]
>  
> <10-1707-51L.S201211><STATION0.HYP><make.out>_______________________________________________
> seisan mailing list
> [email protected]
> http://mailman.uib.no/listinfo/seisan




_______________________________________________
seisan mailing list
[email protected]
http://mailman.uib.no/listinfo/seisan

Reply via email to