|
Folks, I cannot speak to version 8 of SEISAN, but looking at the Version 10 manual on pdf page 139 (actual page number 131), there is a good explanation of this: 7.2.11 Determine azimuth of arrival (3 comp or array) and component rotation If a 3 component station is available, the azimuth of arrival can be determined using the method developed by Roberts et al. [1989]. Display any of the 3 components and press h (Azim). Then select a zoom window around the P-arrival of a few secs duration for the analysis. The 3 components will now be displayed below in order Z, N and E and the calculated azimuth, apparent velocity and correlation will be displayed at the bottom line. In order to check the stability of the estimate, try different windows and filters. Often, a filter must be used to get reliable results. The displayed azimuth and apparent velocity is only saved in the S-file when an associated phase is picked. THAT PHASE MUST BE PICKED ON THE SINGLE UPPER TRACE SEEN ON THE SAME SCREEN. If there is none, use I or E. The velocity estimate is not very reliable and is dependent on the local velocities. In order to calculate the apparent velocity, the P-velocity of the top layer must be given. The default value is 5.0 km/sec, but another value can be set in the MULPLT.DEF file. To get a good estimate, the correlation coefficient should be as high as possible and positive. The quality of the obtained azimuth can be tested by locating the event with the calculated azimuth weighted out and observe the azimuth residual. Figure 7.10 shows an example. Dear Rakesh, if you intend to locate na event with one single station besides the P and S pickings, you have to calculate the azimuth of the event within mulplt (check manual for details). The azimuth is critical in order to identify the quadrant from where the waves are coming from.Cheers, Nuno Afonso Dias Adjoint Professor/Researcher Instituto Dom Luiz IDL Edif. C8, FCUL, Campo Grande 1749-016 LISBOA Portugal Email: [email protected] Tel.: +351.217500000 (Ext. 28331) Fax: +351.217500977 Also at: Department of Physics Instituto Superior de Engenharia de Lisboa Rua Conselheiro Emidio Navarro, 1 1959-007 Lisbon Portugal ________________________________________ De: [email protected] [[email protected]] Em Nome De [email protected] [[email protected]] Enviado: sexta-feira, 13 de Setembro de 2013 15:29 Para: [email protected] Assunto: [seisan] Problem in locating an earthquake using a single 3-component station Dear Sir, Myself Rakesh S Gosain,and I am a reseach scholar in Wadia Institute Of Himalayan Geology, Dehradun , India. We have a VSAT network to record earthquakes in real time mode and for data analysis purpose we are using Seisan 8.1 (Window version). We wish to locate an local earthquake using a single 3-component station. For the same,we went through the Seisan manual also,but we didn't find the actual process to do it. Therefore we need your kind guidance and please share the program commands or study material, if possible. We look forward to your kind reply. Thanks and Kind regards With Regards, Rakesh Singh Gosain Research Scholar, Geophysics Group WIHG, Dehradun, India _______________________________________________ seisan mailing list [email protected] http://mailman.uib.no/listinfo/seisan _______________________________________________ seisan mailing list [email protected] http://mailman.uib.no/listinfo/seisan |
_______________________________________________ seisan mailing list [email protected] http://mailman.uib.no/listinfo/seisan
