Thanks, Jens- Ah, now that you mention it, I had heard Andy mention an issue with the EW seisan module, but I could not recall the details.
I will ask Jeff Marso which module we use to write the seisan files. Yes, would be good to know what happens to the network code in the SAC files. Its much easier if I don't have to go into the SAC files to after the conversion and correct the header. We are getting close to finishing an import module to read seisan files into swarm. I will let you know when its up and running. Thanks! Wendy <<<<<<<<<<<<<<<>>>>>>>>>>>>>>> Wendy McCausland Seismologist USAID-USGS Volcano Disaster Assistance Program 1300 SE Cardinal Court Building 10, Suite 100 Vancouver, WA 98683 +1 360 993 8985 (office) +1 360 823 7309 (cell) +1 360 993 8985 (fax) <<<<<<<<<<<<<<<>>>>>>>>>>>>>>> On Thu, May 1, 2014 at 6:54 AM, Jens Havskov <[email protected]>wrote: > wendy > > in earlier seisan data, there was no network code or location code, later > it was added in in available space so older files can be read but will not > have these codes. not so sure what happens to component code, but it does > not look right. Lars should know, he wrote that part. > > with respect to EW data, there was a bug in the program writing SEISAN > data until about a year ago, so if you update EW (at least the module > wrting seisan data), the problem should be fixed. > > jens > > On Fri, 25 Apr 2014, McCausland, Wendy wrote: > > In converting seisan files from the seisan distribution >> (2001-01-13-1742-24S.KONO__004 for example), the station name, component >> and >> network ID information are not being translated properly. >> Intead of KONO L0N (presumably or perhaps it ought to be LHZ?) >> KONO (? not sure what the network code is for this file, but that is what >> is >> in the file name) >> >> I get >> KONO >> L0 N for the component and network is simply a single space padded with >> nulls >> >> a screen shot of the SAC plot is attached. >> >> I have similar problems with seisan data created by earthworm and >> converted >> to SAC where the station name becomes KSTNM = KWR SH >> instead of simply KWR >> KCMPNM = SH Z >> instead of SHZ >> and the network is blank. >> KNETWK = >> >> I used seisan9.1 to make the conversions, has this been fixed in newer >> versions or is this a bug in the wavetool program? >> Thanks! >> Wendy >> >> <<<<<<<<<<<<<<<>>>>>>>>>>>>>>> >> Wendy McCausland >> Seismologist >> USAID-USGS Volcano Disaster Assistance Program >> 1300 SE Cardinal Court >> Building 10, Suite 100 >> Vancouver, WA 98683 >> +1 360 993 8985 (office) >> +1 360 823 7309 (cell) >> +1 360 993 8985 (fax) >> <<<<<<<<<<<<<<<>>>>>>>>>>>>>>> >> >> >>
_______________________________________________ seisan mailing list [email protected] http://mailman.uib.no/listinfo/seisan
