I suggest you use the GURALP utility "gcf2msd" as follows;
"gcf2msd *.gcf /net:TU /sys"
net is a wild card for network name and sys is neede (if i correctly remember)
to put in station names in place of sensor ID.
We used this utility in a previous Project to convert a plethora of GCF wave 
files
to miniseed.
After the conversion use SEISEI programme to merge components in to one single 
wave file
in miniseed format.

Good luck

Mehmet


----- Orijinal Mesaj -----
Kimden: "Celeste Bollini" <[email protected]>
Kime: "Ça?lar Özer" <[email protected]>, [email protected]
Gönderilenler: 13 Nisan Pazartesi 2015 17:25:16
Konu: Re: [seisan] Guralp to Seisan (GURSEI)

Dear Caglar

Did you edit gursei.def file in your working directory? I do not know  
much about this topic, but I attached an example (station DSPA)
Good luck!

Celeste
-- 
Celeste Bollini
Facultad de Ciencias Astronómicas y Geofísicas, UNLP


Quoting Ça?lar Özer <[email protected]>:

>
> Dear seisan community,
>
>  I have a conversion problem for Guralp to Seisan (GURSEI). I am   
> doing seamlessly conversion and registration process. When I enter   
> the plot with mulplot section, I don't see the station name (left   
> bottom). Only I see sensor code.
> Do you have any idea what is the problem ?
>
> Thank you
>
> Best Regards
>
> Caglar



----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.


_______________________________________________
seisan mailing list
[email protected]
http://mailman.uib.no/listinfo/seisan

_______________________________________________
seisan mailing list
[email protected]
http://mailman.uib.no/listinfo/seisan

Reply via email to