Hi Shelby,

this may suggest that the response file was made without normalizing if at the refernce frequency of 20 Hz. Seisan calculates the reponse using the paz section and normalization constant, and in this case realizes that it is not normalized. You could try to use jplotresp to see what that reports for the normalization. If that is different from Seisan, we can look at the response file and the seisan code to see if anything is going wrong.

Regards,
Lars


Den 2016-02-05 18:51 skreiv Shelby Peterie:
Dear Seisan community,

We are working with data from the IRIS DMC.  Our goal is to calculate
ML with these data, so we copied the RESP files from IRIS into
Seisan's CAL directory for instrument response correction (this
particular station is normalized at 20 Hz).  When we apply the
Wood-Anderson filter in MULPLT, we get the following error message:

paz not normalized, stage =            1
amplitude at    20.000000      Hz =   0.88832253
a0 changed to    1.1257173​

And our resulting ML are not what we expect (generally too small).
Does this error indicate a problem with the response file, or a
problem in Seisan such as a parameter in a configuration file I need
to change?  Any ideas?

Thank you in advance for your help.
Sincerely,
Shelby
_______________________________________________
seisan mailing list
[email protected]
http://mailman.uib.no/listinfo/seisan

_______________________________________________
seisan mailing list
[email protected]
http://mailman.uib.no/listinfo/seisan

Reply via email to