You can use any '89 and later 2.2 crankshaft, cast or steel. You can also use any of the TII or 2.5 TI rods but remember that the R/T motor uses a non stretch rod bolt and all other 2.2 and 2.5 motors use a torque and stretch bolt so either get another TIII rod or replace the set with a set of TII/2.5 TI rods.
I have a good TIII shortblock. It's apart and everything is standard size. I can sell it like this (you assemble it or use what you need) or assembled with new rings, bearings, oil pump, gaskets and seals (just drop it in and go) Cliff Ramsdell VP New England SDAC www.sdacne.com '86 GLHS 065 Going back to stock "appearing" '29 Model A, 239 flathead V-8, 3 speed [EMAIL PROTECTED] http://www.members.aol.com/mopartek/home.html In a message dated 4/17/2005 11:02:11 PM Eastern Daylight Time, [EMAIL PROTECTED] writes: > Hey everybody! I just spun a couple rod bearings in my > iroc r/t and chewed up my crankshaft and rods and was > wondering if the stock crank out of an 88' 2.2 TI > would work? or what other cranks and rods would work > in the TIII motor. > > Thanks for any help! -----------------------REMOVE-FOOTER-WHEN-REPLYING---------------------------- Questions? Visit http://www.sdml.org/ To be removed, visit http://www.sdml.org/pages/leave.html
