RE: ShopTalk: Memphis 10 / Dynalite riddle

[Jonathan LaChance]

Jeff, Do you have access to the 4 & 6 Irons? If so Measure the groundline to first step on those two and split the difference. If you end up needing to extend the shaft a bit that would not be then end of the world.   Good luck JP LaChance ccugolf.com -----Original Message----- From: Jeff Stephens [mailto:[EMAIL PROTECTED]] Sent: Tuesday, June 25, 2002 7:46 PM To: [EMAIL PROTECTED] Subject: ShopTalk: Memphis 10 / Dynalite riddle I can't figure this one out, but I am certai someone out there in ShopTalk land can.   I'm reshafting a broken Callaway S2H2 5 iron. 38" length with a Memphis 10 shaft.   The Golfsmith Shaft Replacement guide says use the Dynalite "A" flex for the Memphis 10   The Dynalite A/L is 40" long, recommended tip trim is 3" for a 5 iron. That leaves me with a club shorter than 38"   Do I: !. Put a shaft lengthener in the but?   2. Fudge on the tip trip?   3. Use a shaft other than Dynalite A/L         3a  Use a Dynalite Gold R300 and not tip trim as much         3b. Use a TX90 "A" which is almost a duplicate DSFI to the Dynalite "A"   4. None of the above but ________________________________ (y'all fill in the blank)   I await your wisdom.   Jeff Whole-in-One ____________________________________________________   IncrediMail - Email has finally evolved - Click Here