Thanks. I must have tipped it and forgot about it. It will work out OK
though as I am using them in 5&7 woods.
On Tuesday, December 21, 2004, at 12:14 AM, John Payne wrote:
Brian
Measured it again, it's 29". On mine 27" takes you to the Apache's
head.
John
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On
Behalf Of Brian Lyall
Sent: Monday, December 20, 2004 9:51 PM
To: [EMAIL PROTECTED]
Subject: Re: ShopTalk: Apache PM30+ Question
John sure its 29". Mine came out at 27" and I didn't think I tipped it
at
all. I'm probably wrong but just want to verify.
John Payne writes:
Brian
It's 29" exactly. Flew over CYYR last week, looked cold down there.
Merry Christmas,
John
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Brian Lyall
Sent: Monday, December 20, 2004 2:43 PM
To: [EMAIL PROTECTED]
Subject: ShopTalk: Apache PM30+ Question
I have a couple of Apache PM30+ wood shafts, R1 or R2 flex. The
problem is I cannot remember how they were tipped. If someone has one
around that is untipped or tipped a known amount, could they measure
fro the tip to the band on the butt end that has C.F.I on it? I can
then figure out how much they have been tipped.
