Plug the hole with a tapered plastc plug. Secure with epoxy (use small amount). You can use an old toothbrush handle to make the plug.
Sent from AOL Mobile Mail -----Original Message----- From: Mats Bengtsson <i...@mbaudio.se> To: ShopTalk <ShopTalk@mail.msen.com> Sent: Wed, Nov 16, 2016 07:08 AM Subject: ShopTalk: Need to cover hotmelt hole. Hi I have a head with a 3 mm hole in it, probably a hotmelt hole, but I donĀ“t need that, so how do I plug it? I tried with golf club glue but that was a bit too runny, so it was hard to get it to stay. Any good suggestions would be appreciated. Regards Mats B-- Shoptalk ** Sponsored by the new Aldila Voodoo. Learn more at <a href="http://aldilavoodoo.com/" target="_blank">http://aldilavoodoo.com/</a>