I'm trying to get TPROXY / Squid running and I have a few questions... I found this page: http://www.shorewall.net/Shorewall_Squid_Usage.html#TPROXY
However, it doesn't explain what I'm seeing in the configuration. For the zone file, do I keep my loc and net configurations and just add the following to the file? - lo - - or do I remove the loc and net zones and replace it with the above line? When I try to use the following line in providers: Tproxy 1 1 - lo - local and this line in tcrules TPROXY(1,3128) eth0 0.0.0.0/0 tcp 80 and finally these lines in rules ACCEPT loc $FW tcp SP (or) (ACCEPT lo $FW tcp SP) ACCEPT $FW net tcp 80 I get an unknown source zone (lo). What am I looking at here? I'm assuming that this perspective is configuring the inside going out. Eth0 is loc (local) zones: fw firewall loc ipv4 net Interfaces: - lo - - loc eth0 detect routeback net eth1 Where does "lo" come into play? What is this doing? When it is said on the page that we assume Z is eth1. What is eth1? Is that the local our net interface? In my case would the "Z" in the rules section be loc or net then? I was assuming that in this page "Z" was referring to the inside (local) NIC. Also what is DEST PORT SP ? Thanks! Scott ------------------------------------------------------------------------------ ThinkGeek and WIRED's GeekDad team up for the Ultimate GeekDad Father's Day Giveaway. ONE MASSIVE PRIZE to the lucky parental unit. See the prize list and enter to win: http://p.sf.net/sfu/thinkgeek-promo _______________________________________________ Shorewall-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/shorewall-users
