I couldn't find nwa package, the link on http://wiki.openmoko.org/wiki/NWA
doesn't bring to a page where to download it.
About iliwi, I've already used it. It correctly brings the interface up,
but after this it can't manage to use a static IP. If after running iliwi
I run my script twice, then the correct IP address and network parameters
are set. However I find this way to be a bit over elaborate... Even by
setting /etc/nework/interfaces with static IP, etc doesn't work, iliwi
keeps on state "connecting" forever.
Actually iliwi doesn't allow to set a static IP, maybe I could set it with
the other network parameters in the wpa supplicant configuration file? If
yes, do you know? Can a custom script be loaded inside the wpa conf file?
If not which parameters should I write inside the wpa conf file?
Thank you
On Tue, 18 May 2010 00:07:25 +0200, Joachim Ott
<[email protected]> wrote:
On 17 May 2010 21:56, urodelo
<[email protected]> wrote:
Thank you again for your help. I get:
#dmesg | grep -i -e mmc1 -e ar6000
[21474566.340000] mmc1: queuing CIS tuple 0x01 length 3
[21474566.360000] mmc1: queuing CIS tuple 0x1a length 5
[21474566.365000] mmc1: queuing CIS tuple 0x1b length 8
[21474566.375000] mmc1: queuing CIS tuple 0x80 length 1
[21474566.375000] mmc1: queuing CIS tuple 0x81 length 1
[21474566.375000] mmc1: queuing CIS tuple 0x82 length 1
[21474566.375000] mmc1: new SDIO card at address 0001
[21474568.110000] AR6000 Reg Code = 0x40000060
[21474569.365000] AR6000 disconnected
[21474579.280000] AR6000 disconnected
[21474632.435000] mmc1: card 0001 removed
[21474632.505000] ar6000_wow interrupt
Can try installing nwa - just to enable the interface, then run your
script.
I don't know if iliwi supports static ip, but that would be another try.
_______________________________________________
Shr-User mailing list
[email protected]
http://lists.shr-project.org/mailman/listinfo/shr-user
