Hello Jörg,
I could be wrong, but it's my understanding that flashing green LED means
that DSLogic waits for a trigger condition and doesn't send any data.
On Wed, Apr 4, 2018 at 11:27 AM, Jörg <jalp...@gmx.net> wrote:
> Hello,
>
> the dslogic driver should work with parameter "--continuous".
> Unfortunately, I do not receive any UART data.
>
> My call is:
>
> SIGROK_FIRMWARE_DIR=/usr/local/share/sigrok-firmware/dslogic_firmware
> ./sigrok-cli --driver dreamsourcelab-dslogic
> --config samplerate=2000k:voltage_threshold=1.5-1.5
> --continuous -P uart:baudrate=9600 -B uart=rx
>
> The LED color changes from red to green flash
>
> Even after ten minutes no change. Nothing is spent!
>
>
> A Logic16 clone will deliver at the same circuit with call
>
> ./sigrok-cli --driver saleae-logic16 --config samplerate=2000k
> --continuous -P uart:baudrate=9600 -B uart=rx
>
> correct Ascii data.
>
>
> Jörg
>
> ------------------------------------------------------------
> ------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, Slashdot.org! http://sdm.link/slashdot
> _______________________________________________
> sigrok-devel mailing list
> sigrok-devel@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/sigrok-devel
>
--
Best regards,
Aleksander Alekseev
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
sigrok-devel mailing list
sigrok-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/sigrok-devel
