Hi,

I'm new to the mailing list and sigrok and have a lot of problems using
the programs.

I have a rigol mso1104z, a korad ka3005p and a unit-t ut61b, all devices
should be fully supported as the wiki stated.

Yesterday I compiled all sigrok programs from git (using the corr.
script) to be shure to have the newest version (get version 0.5.. for
pulseview).

My problems are:

1. I found no manual or even tipps with a simple description how to use
   the cli or a gui with a device and get the features of that device -
   for example for ka3005o and ut61b.

2. Pulseview mostly crashes and only shows only one wave (from a dcf77
   source) and only with 20 ms hori. resolution and than stops. How can
   I see more?

3. The network address and the device type needs always put in again
   after restart/crash. Why can the values (IP, port, device) not be
   saved and reloade - best in a config-file?

4. How can I help to make the programs or dokumentation better. I can
   compile the programs with the debug-flag and run them with gdb but I
   think I can't program new features (at least now).

Fine regards
Rolf

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
sigrok-devel mailing list
sigrok-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/sigrok-devel

Reply via email to