When a light beam moves through a medium with material which is either
reflecting, or of a different coefficient of refraction in a suspended
state, then some of the light will be scattered.  This is seen often by
viewing sunlight coming in a window where you can see the dust
particles, or seeing the sun beams coming down from holes in the
clouds.  In the case of colloidal silver you have silver particles which
scatter the light when suspended in water.

The tyndall effect is very nice for determining that you have a
suspension or colloid, but is extremely unreliable for determining how
much you have.  There are two reasons for this:

For particles much smaller than the wavelenght of light, such as
colloidal silver, the amount of scattered light is defined by I =
kNV^2/y^4, where k is a proportional constant, N is the number of
particles, V  is the volume of one particle, and y is the wavelength of
the light.  Thus if we go from a particle size of 1nm to 10 nm, then V
will go up by a factor of 10^3 or 1,000.  N will go down (for the same
ppm) by a factor of 1,000, resulting in the product of the Number by the
square of the Volume increasing by a factor of 1,000.  Thus for the same
ppm colloid, 10 nm particles will have 1000 times as much Tyndall as a
colloid with 1 nm particles.  This makes it pretty hard to use Tyndall
effect for any kind of quantitative analysis.  Higher ppm colloids will
often have much bigger particles, much higher tyndall, yet only slightly
more particles per ounce than low ppm colloids.

The other factor is that the amount of Tyndall varies inversely to the
4th power of wavelenth of the light.  This results in the Tyndall for
blue light being much greater than the Tyndall for red light.  This is
the reason the sky is blue and skimmed milk has a blueish tone, by the
way.  Anyway, unfortunately most people use red lasers to check the
Tyndall, and thus are using the worst possible wavelength for the
effect, but normally it is still works quite well.

I hope this answered your question.

Thanks,

Marshall

Richard Ausili wrote:

>   Could someone please explain the Tyndall effect? Thanks.
>
> Richard Ausili
> [email protected]