The only difference was the run time. My guess is the way the tds works,
the yellow CS may have more silver in it but larger particles and less
total surface area of silver. The 2 hour clear may have less silver but
more surface area because the particle size is smaller. A analogy would
be two cups with water, one with two ice cubes floating, the other with
one ice cube crashed and floating. If the ice were conductive the
crushed ice would more likely have a flow. 


On Thu, 10 Jun 1999 13:16:13 -0500, "Scharbach" <[email protected]> wrote:
> A higher ppm on a 2 hour batch of silver than on a 12 hour batch?
> DId you do something else different?
> Sparrow

>> My tds1 came today and after calibrating checked out my CS.

>> HVAC 2 hour batch - 26 ppm. clear, light tyndall
>> HVAC drip 2 minute batch 3 ppm. clear, very light tyndall
>> LVDC 12 hour batch 6 ppm, yellow, very strong tyndall
>> LVDC 2 hour batch, 12 ppm clear, good (distinct) tyndall

>> If I remember right the folks who use these to monitor their production
>> figure the CS ppm as 1/2 the tds1 meter reading? This has been verified
>> by other testing if memory serves.

>> Please clarify if possible. Thanks...RONjb


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]

List maintainer: Mike Devour <[email protected]>