I purchased a meter with a 0.1 microsiemenss resolution, Water Wise brand from CS Pro, $180.00. The problem with the cheap meters is they are generally hae a 1.0 resolution, which is not good enough for measuring the distilled water before starting. I'm sure there are may other brands available.
For those of you who get varied results, checking the water made the world of difference to me. Even with the best brand I buy, out of 5 gallons it is not unusual to throw away 2 or 3, as the longer the distilled water stays in the bottle, the higher the conductivity becomes. I try to use water within the range of 0.7 to 1.2 microsiemens. Jim Sharon L. House wrote: > Jim, > > Where do you get one of these meters? And how much do they cost? > > Thanks, > > Sharon > > >What ever happened to the very worthwile notion of standardizing on > >microsiemens, and discouraging tds readings? > > > >If this list is about trying to further cs development and use, does it > >not make sense to use real measurement (microsiemens) and discourage > >numbers from tds meters, with are, at best, fickle? > > > >Rather than every newbie getting a tds, only to realize the readings > >mean virtually nothing, why don't we make it a standard and encourage > >everyone to get a meter which reads in microsiemens? At least then, > >when someone has a question, there is a "real" reading of conductivity > >for others to use for information. > > > >Regards, > > > >Jim > > > >PS FOR NEWBIES: The reason TDS meter readings are not much help is > >because nobody knows how everyone else's is calibrated. If everyone is > >reading the same batch, yours might read 20, mine might read 45, the > >next guy's might read 6. The number has virtually no meaning on list > >discussions. (A person might use a tds as a "consistency" measurement > >which may help you at home, but differences in calibration make it > >useless as a ppm meter on list discussions.) ALSO: If you have 10 > >batches of tested and confirmed 30 ppm cs, you may read one at 5 ppm, > >one at 120 ppm, one at 40 ppm, etc. This is due to the particle sizes > >being different, which the average person has no way of accurately > >measuring at home. So the measurement in this case is not even as good > >as a guess. > > > >While the particle size consideration does not go away with using > >microsiemens, the calibration part does, so fully half of the confusion > >is instantly eliminated. (Means we are already that much closer to > >being able to help out with questions.) > > > > > >-- > >The silver-list is a moderated forum for discussion of colloidal silver. > > > >To join or quit silver-list or silver-digest send an e-mail message to: > >[email protected] -or- [email protected] > >with the word subscribe or unsubscribe in the SUBJECT line. > > > >To post, address your message to: [email protected] > > > >List maintainer: Mike Devour <[email protected]> > > -- > The silver-list is a moderated forum for discussion of colloidal silver. > > To join or quit silver-list or silver-digest send an e-mail message to: > [email protected] -or- [email protected] > with the word subscribe or unsubscribe in the SUBJECT line. > > To post, address your message to: [email protected] > > List maintainer: Mike Devour <[email protected]> -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: [email protected] List maintainer: Mike Devour <[email protected]>

