More grist for the mill. We have been manufacturing a constant current generator for about 10 months now and have always used a constant current of 1 milliampere. We start out at 40 volts and the voltage drops to maintain that current. We do not have any problem with temperature control. Within normal temperature ranges, we cannot discern any change in current. The voltage will drop to as low as 3 or 4 volts during regular colloid production.
We looked at all the sites on the web selling colloidal silver generators and found one other company touting constant current before we went online. However, that unit was current limited at 20 milliamps. I doubt the current ever reached that setting during colloid production. With constant VOLTAGE units I sometimes see currents of 7-8 milliamperes. Never 20 ma. We advertised ourselves as manufacturers of the "Original Constant Current Colloid Generator" and still stand by that statement. If anyone would care to let me know by separate E-mail who the other manufacturers are, I would appreciate it. Trem Williams [email protected] > Oh wise ones, > > Fairly new to cs, have had gen for couple of months, makes good cs (had some tested), but am curious about making cs with constant current. Would someone make a post here and explain how you people are doing this? > I'm all eyes!!! > > Earle I'm not so wise, but I can give you some info about constant current. Constant current is a bit of a misnomer actually. It is very hard to supply a constant current when the voltage is continually changing, better to think of limiting the current to some maximum. Also most current limiting devices are very temperature dependent and are often used in temp sensing applications. The easiest current limiting device is the common L317T voltage regulator. With the input leg of this connected to the positive out of your generator and the adjust leg connected to your electrode, you then tie the output leg to the adjust leg via a resistor or variable resister with the formula: current out = 1.25 divided by the resistor value. This limiter is not absolutely stable (not constant) for currents less than 10mA but is good enough. Bob Lee posted on this subject previously and is probably much easier to understand than me. Ivan. > Seems that more people are listening now and using constant current > methods to make smaller particles. Now if more folks would get on the > current density bandwagon the CS would get even better. Makes me smile > when I read all the posts where folks act like they did something new, > when I was posting it for the last year. Got some new things coming up > anyway. Did a survey of CS web sites two years ago (saved on disk) and > not a single one mentioned constant current or current density. Re- > surveyed again last month and most all of them are now talking constant > current and some are into current density. :-) One generator maker is > offering machines that almost operate on the starved electrode method as > often posted by me. Get smiles when new techies show up and start > pontificating about their knowledge and understanding of CS. Recall a > post I had made and the very next day its content showed up on six > sites. :-) > I see the CS becoming better and more effective as we learn to taylor > it for the application. Thats very good. > Bob Lee >>snip<< I must say that a post by Bob (starved electrode etc.) in the middle of last year, helped me to understand just what was going on with some tests I had done when I could not find answers anywhere else. His opinions are most valuable. I too have championed the current limit protocol at a lower current probably than most, but have noticed recently a couple of generators that limit to 0.5mA who seemed to have arrived at this point independently. Some people out there are thinking. Ivan.

